Panel Installation

ManualsBrandsKitchenAid ManualsHousehold Appliance24 in. Top Control Dishwasher in Panel-Ready with Stainless Steel Tub, ProWash Cycle

INSTALLATION INSTRUCTIONS

FOR CUSTOM PANEL ATTACHMENT

UNDERCOUNTER DISHWASHER

STAINLESS STEEL TUB

IMPORTANT: Before installing your dishwasher, please use this instruction sheet as a supplement to the installation instructions.

Custom Panel models only

Gather these additional tools and parts before starting attachment

of the custom panel. Read and follow the instructions provided in

this Instruction Sheet.

Additional Tools Needed:

³⁄₃₂" Drill bit

Additional Parts Supplied with Custom Panel Models:

Plastic studs (attached to each other by runners) (4)

Short screws (10-16 hex-head screw) (4)

Long screws (8-18 Torx

head screws) (4)

Template (1) (located inside Use and Care Guide bag assembly)

Instruction sheet (1) (located inside Use and Care Guide bag

assembly)

NOTE: The screws supplied are used for only 3¾" (9.5 cm) thick

wooden panel. If the wooden panel is less than 3³⁄₈" (8.6 cm) thick,

customer must purchase screws locally.

Make sure all these parts are included in the literature package.

If parts are not included, call 1-800-422-1230. In Canada, call

1-800-807-6777.

Install Custom Panel

Follow Steps Below:

A customer supplied panel must weigh no more than 16 lbs

(7.3 kg) and must be made to specific dimensions. It is

recommended that a cabinetmaker cut the customer panel

because of the precise dimensions needed.

NOTES:

■ The handle for the custom panel is not included.

■ All mounting hardware supplied is for a ³⁄₄" (19.1 mm) thick

wood panel. If a thinner wood panel or materials other than

wood are used, it is the customer’s responsibility to obtain the

proper length screws and adjust the pilot holes accordingly.

IMPORTANT: Use a moisture-resistant sealer on both sides and

all edges of the panel to avoid damage from moisture.

W10750117A

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR CUSTOM PANEL ATTACHMENT UNDERCOUNTER DISHWASHER STAINLESS STEEL TUB IMPORTANT: Before installing your dishwasher, please use this instruction sheet as a supplement to the installation instructions. Custom Panel models only Install Custom Panel Gather these additional tools and parts before starting attachment of the custom panel. Read and follow the instructions provided in this Instruction Sheet.
PAGE 2
WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. Using the template provided, attach it to the backside of the custom panel with tape. Make sure that the center of the template is aligned with the center of the wooden panel and top of the template is aligned to the top face of the wooden panel. Using 2 or more people, stand the dishwasher up. NOTE: Do not install kick plate until instructed to do so.
PAGE 3
Check custom tape alignment with metal door slots; verify tape is right-side up, and that the tape does not overhang the metal door on the top, bottom or side interfaces. Remove the backing from the custom tape by pulling straight down on the liner. Align the custom tape to the keyhole slots on the metal door (see “5 Attach custom tape) and apply. Repeat steps for one side and then the other.
PAGE 4
® W10750117A /™ ©2014 Whirlpool. Used under license in Canada. All rights reserved. Usada en Canadá bajo licencia. Todos los derechos reservados. Utilisé sous licence au Canada. Tous droits réservés. 11/14 Printed in U.S.A. Impreso en EE.UU. Imprimé aux É.-U.