Instruction for use
Installation ............................................................................................................................................ 4 Product description .............................................................................................................................. 5 First time use ......................................................................................................................................... 6 Advice and tips ....................................
Before using the appliance carefully read Health and Safety guide. INSTALLATION ATTENTION: If the appliance must be moved at any time, keep it in an upright position; if absolutely necessary, it may be tilted onto its back. CONNECTING THE WATER SUPPLY ELECTRICAL CONNECTION Adaptation of the water supply for installation should only be performed by a qualified technician. The water inlet and outlet hoses may be positioned towards the right or the left in order to achieve the best possible installation.
The control panel of this dishwasher activates pushing by ON/OFF button. For energy saving the control panel deactivates automatically after 10 minutes if no cycle has started. PRODUCT DESCRIPTION 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13.
FIRST TIME USE After connecting the appliance to the power supply for the first time, the display will guide you to set up the appliance for first use. Make sure the cap is screwed on tightly, so that no detergent can get into the container during the wash program (this could damage the water softener beyond repair). Once done, proceed to the next step by pressing „SET” button. 1.
8. First cycle operation 1. Open the dispenser B by pressing and pulling up the tab on the lid. 2. Carefully introduce the rinse aid as far as the maximum (110 ml) reference notch of the filling space A - avoid spilling it. If this happens, clean the spill immediately with a dry cloth. 3. Press the lid down until you hear a click to close it. 4. Confirm operation by pressing „SET” button.
ADVICE AND TIPS TIPS UNSUITABLE CROCKERY Before loading the baskets, remove all food residues from the crockery and empty the glasses. You do not need to rinse beforehand under running water. Arrange the crockery so that it is held in place firmly and does not tip over; and arrange the containers with the openings facing downwards and the concave/convex parts placed obliquely, thus allowing the water to reach every surface and flow freely.
UPPER RACK ADJUSTING THE HEIGHT OF THE UPPER RACK The height of the upper rack can be adjusted: high position to place bulky crockery in the lower basket and low position to make the most of the tip-up supports by creating more space upwards and avoid collision with the items loaded into lower rack. The upper rack is equipped with a Upper Rack height adjuster (see figure), without pressing the levers, lift it up by simply holding the rack sides, as soon as the rack is stable in its upper position.
SELECTING A CYCLE AND OPTIONS The list of available cycles and options can be found in Cycle Table on next page. Eco cycle is selected by default. If you want to have Last Used cycle selected by default, you can change it in „Settings Menu”. MODIFYING A RUNNING PROGRAM If a wrong program was selected, it is possible to change it, provided that it has only just begun: open the door, press and hold the „ON/OFF” button, the machine will switch off.
CYCLE Available options * Detergent dispenser B ECO 50° TUB Duration of wash cycle (h:min)* Water Energy consumption cosumption (l/cycle) (kWh/cycle) TABLET, START DELAY, DYNAMIC CLEAN, BOOST 3:40 9.5 0.74 DYNAMIC SENSOR 50-60° TABLET, START DELAY, MULTIZONE, DYNAMIC CLEAN, BOOST 1:25 - 3:00 7.0 - 14.0 0.90 - 1.40 PROFESSIONAL 65° TABLET, START DELAY, MULTIZONE, DYNAMIC CLEAN - 2:27 16.5 1.70 DAILY 50° TABLET, START DELAY, MULTIZONE - 1:30 13.0 1.
OPTIONS AND SETTINGS With each cycle additional options can be used. A full list of available options working with specific cycles can be found in the Cycle Table on the previous page. All active options are shown on the display. To set an option press „SET” button. SET OPTIONS message is shown for a few seconds. Then use „<” or „>” button to navigate through the option list. Press „SET” to select the option, in the setting menu the LED above „SET” button is lit.
SETTINGS MENU To change machne settings you need to enter into the Settins Menu. Press „SET” button and navigate with „< , >” until SETTINGS is shown, then press „SET” button. To exit the setting menu, press any cycle button or press „< , >” button untill EXIT is shown, then press „SET” button. Language Tub Light 1.LANGUAGE OK 1.ITALIAN <> To change language, enter in the setting menu by pressing „SET” button and navigate with „< , >” until „LANGUAGE” is shown, then press „SET” button. 1.ENGLISH 7.
CARE AND MAINTENANCE ATTENTION: Always unplug the appliance when cleaning it and when performing maintenance work.Do not use flammable liquids to clean the machine. CLEANING THE DISHWASHER Any marks on the inside of the appliance may be removed using a cloth dampened with water and a little vinegar. The external surfaces of the machine and the control panel can be cleaned using a non-abrasive cloth which has been dampened with water. Do not use solvents or abrasive products.
TROUBLESHOOTING Your dishwasher may not work properly. Before contacting the After-sales Service, check if the problem can be solved by going through the following list. PROBLEMS Display shows: CHECK SALT or ADD SALT POSSIBLE CAUSES SOLUTIONS Salt reservoir is empty. Refill reservoir with salt (see page 6). Adjust water hardness (see page 6). Rinse aid dispenser is empty. Refill dispenser with rinse aid (see page 6). Display shows: CHECK RINSE AID or ADD RINSE AID The appliance must be switched on.
PROBLEMS POSSIBLE CAUSES SOLUTIONS The door doesn’t lock. Racks are not fit to the end. Verify that racks are fit to the end. The door is not lock. Vigorously push the door until you hear the “clack” sound. The dishes are rattling against each. Arrange the crockery correctly (see Loading the Racks). An excessive amount of foam has been produced. The detergent has not been measured out correctly or it is not suitable for use in dishwashers (see Filling the Detergent Dispenser).
AFTER-SALES SERVICE PRODUCT FISCHE The technical data containing the energy consumption data can be downloaded from the website: http://docs.kitchenaid.eu CONTACTING AFTER-SALES SERVICE You can find our contact details in the warranty manual. When contacting our Client After-sales Service, please state the codes provided on your product’s rating plate.
Printed in Italy 11/17 400011168106B EN
