Instructions for use
Important safety instructions 4 Installation 5 Advice on safeguarding the environment 6 Troubleshooting guide 6 After-Sales Service 7 Cleaning 7 Maintenance 8 Material supplied 9 Installation - Preliminary assembly instructions 10 Installation dimensions 11 Installation - assembly instructions 12 Description and use of hood 13
Important safety instructions YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT. This manual and the appliance itself provides important safety messages, to be read and observed at all times. • The appliance is not intended for use by people (including children) with limited physical, sensory or mental abilities or without experience or knowledge of it, unless they are supervised or instructed in its use by someone responsible for their safety.
correctly installed - risk of electric shock. • Wear work gloves for all installation and maintenance operations. • The product is not suitable for outdoor use. • When the hob is in use, the accessible parts of the hood can become hot. • For further information on the treatment, recovery and recycling of this appliance, contact the competent local authority, the household waste collection service or the shop where you purchased the appliance.
Advice on safeguarding the environment - By ensuring the correct scrapping of this product, the user can help prevent potentially negative consequences for the environment and the health of people. Packing disposal The packing materials are 100% recyclable and are marked with the recycling symbol ( ). The various parts of the packing must not be dispersed in the environment, but disposed of in compliance with the local regulations.
After-Sales Service Before contacting the After-Sales Service: 1. See if you can eliminate the problem on your own by consulting the "Troubleshooting guide". 2. Switch the hood off and then on again to check if the problem has been eliminated. If the following faults occur, contact the After-Sales Service immediately: • The hood makes strange noises and you are unable to detect any fault in it; • The motor runs unevenly, or strange noises can be heard, or it is faulty; • Switching does not work regularly.
Maintenance WARNING • Use protective gloves. • Disconnect the appliance from the power supply. GREASE FILTER Its purpose is to retain the particles of grease produced by cooking. It must be cleaned every 14 days or after 15 hours of operation, when the LED on the appliance signals this need. Use gentle and non-aggressive detergents, clean it by hand or in a dishwasher at low temperature and with a short cycle.
Material supplied Remove all the parts from the packets and make sure all the components listed below are included. • • • • • • • • 4+4 Plugs Ø10 4 washers 4 Threaded sleeves 4+4 Screws M8 4+4 Nuts 1 Threaded rod: length 100 cm Flange Ø20 cm Remote control The material for the external motor, included in the previous list, is supplied separately in the motor packing.
Installation - Preliminary assembly instructions WARNING • Installation and maintenance must be carried out by a specialised technician. The hood is designed for installation and use in "Extractor Version". The hood must be installed away from very dirty areas, windows, doors and heat sources. IMPORTANT: The hood comes with all the material necessary for installation on the majority of ceilings.
Installation dimensions IMPORTANT: For the operation of this hood, it is necessary to install the external motor included in a separate pack. IMPORTANT: For gas hobs, the maximum total power is 16.2 kW.
Installation - assembly instructions WARNING • Installation and maintenance must be carried out by a specialised technician. • Very heavy product; hood handling and installation must be carried out by at least two people. The instructions below, in numerical order, refer to the drawings (giving the same numbering) in the "Installation instructions" manual. 1. Position the external motor and fix it using the material supplied.
Description and use of hood 1. 2. 3. 4. 5. 6. 7. 8. 9. Hood body Extraction panel Cylindrical actuator Switch IR sensor Lighting Grease filters LED indicators Anchoring to ceiling. The hood functions and the external motor performance can be controlled in two alternative ways by means of the remote control or the switch on the main body of the hood. Operation using the remote control The 2010 remote control model has six control buttons. • Button 1: Switches the hood on or off.
• Battery Compartment: The battery compartment is located in the back of the remote control. Only use CR2032 3V lithium batteries. Replacing the batteries: the battery compartment cover is located on the back of the remote control. Lift it with thumb and forefinger until separating the magnetic contact keeping the cover closed. Remove the old batteries and replace them with new ones of the same type, then refit the cover. IMPORTANT: The maximum operating range of the remote control is 5 m.
Printed in Italy 06/11 5019 718 02046 n GB