5KEK1722 INSTRUCTIONS
TABLE OF CONTENTS ELECTRIC KETTLE SAFETY Important safeguards .......................................................................................... 3 Electrical requirements ...................................................................................... 4 Battery activation (optional) ............................................................................... 4 PARTS AND FEATURES Parts............................................................................................................
When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all instructions. 2. Do not touch hot surfaces. Use handles. 3. Do not submerge cord, plug, or Electric Kettle in water or other liquids. 4.
Electrical requirements Voltage: 220-240 Volts Frequency: 50/60 Hertz Wattage: 2400 Watts Do not use an extension cord. If the power supply cord is too short, have a qualiÀed electrician or serviceman install an outlet near the appliance. Battery activation (optional) NOTE: If batteries have been added and the Electric Kettle is off the base, the display will show the current temperature of the water.
Lid release button :DWHU ÀOO location Control panel :DWHU ÀOWHU 1.
%HIRUH ÀUVW XVH Before first use, fill the Electric Kettle to the maximum level, then boil and discard the water. The temperature can be displayed in Celsius (C) or Fahrenheit (F). To change setting, hold the “-” and “+” buttons down at the same time. NOTE: The Electric Kettle is designed for water only. Do not put any other liquids or substances in the Electric Kettle. Filling the Electric Kettle with water 1 Open the lid of the Electric Kettle by pressing the Lid Release Button.
°C °F 50 122 60 140 70 158 80 176 90 194 100 212 1 Place the Electric Kettle on the base. The display will show the default temperature (100° C / 212° F). Press the “+” or “-” buttons to select your desired water temperature. See the “Temperature guide” for more information. The Electric Kettle has six programmed temperature settings. 2 Press the START/CANCEL button to save temperature and to begin heating the water.
Heating water NOTE: The temperature will blink 5 times and return to standby after 5 seconds. This will continue until after the water temperature reduces below the desired temperature. Temperature guide Use this guide for outstanding results from your KitchenAid® Electric Kettle.
Turning off the Electric Kettle English The Electric Kettle can be turned off in several ways: 1 Press Start/Cancel while in heating mode. Unplug cord when Electric Kettle is not is use. 2 Press Start/Cancel while in Keep Warm mode. Unplug cord when Electric Kettle is not is use. 1 The exterior of the Electric Kettle may be cleaned with a damp cloth. Dry and polish the Electric Kettle with a soft cloth. Abrasives and scouring agents of any kind are not recommended.
&OHDQLQJ WKH ÀOWHU The Electric Kettle features a removable mesh Àlter that traps scale deposits for cleaner water. The Àlter will need to be cleaned periodically³more often if you have hard water. 1 To access filter: Open the lid; the filter is located behind spout inside Electric Kettle. Grasp the top of the filter to remove. 2 Clean under hot water with a soft brush or cloth to remove deposits, and replace filter by sliding the filter into the slot behind the spout.
© 2013. All rights reserved.