FREESTANDING OUTDOOR GRILL Installation Instructions and Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-877-373-2301 or visit our website at www.Kitchenaidgrills.com ASADOR AUTÓNOMO PARA EXTERIOR Instrucciones de instalación y Manual de uso y cuidado Para consultas respecto a características, funcionamiento, rendimiento, piezas, accesorios o servicio técnico, llame al: 1-877-373-2301 o visite nuestro sitio de internet en www.Kitchenaidgrills.
TABLE OF CONTENTS OUTDOOR GRILL SAFETY ................................................................. 3 INSTALLATION REQUIREMENTS.................................................... 5 Tools and Parts ........................................................................................ 5 Location Requirements............................................................................ 5 Product Dimensions.................................................................................
OUTDOOR GRILL SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electrical shock, injury to persons, or damage when using the outdoor cooking gas appliance, follow basic precautions, including the following: ■ Do not install portable or built-in outdoor cooking gas appliances in or on a recreational vehicle, portable trailer, boat or in any other moving installation. ■ Always maintain minimum clearances from combustible construction, see “Location Requirements” section.
INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Needed ■ Tape measure ■ Pipe wrench ■ Small, flat -blade screw driver ■ ■ #2 and #3 Phillips screw driver Scissors or cutting pliers (to remove tiedowns) ■ Level ■ Noncorrosive leakdetection solution ■ Wrench or pliers Parts Supplied ■ Gas pressure regula tor/hose assembly set for 11" WCP LP gas.
Product Dimensions Built-In Outdoor Grill Enclosure WARNING Fire Hazard Do not install grill on or near combustible materials. Doing so can result in death or fire. The enclosure for the built-in outdoor grill is to be a minimum of 11" (28.0 cm) high x 23" (58.4 cm) deep x 30" (76.2 cm) wide This built-in outdoor grill is only for installation in a built-in enclosure constructed only of noncombustible materials. Non-combustible materials could be brick, firewall or steel.
Cabinet Cutout Dimensions The illustration bel ow includes cutout dimensions and minimum spacing requirements. The illustration is for reference. The design of your cabinet layout can be personalized, but the dimensions for the cutouts and minimum spacing must be followed. Center or support surfaces must be level. The installation of this grill must conform with local codes or, in the absence of local codes, with either the National Fuel G as Code, ANSI Z223.
■ To ensure that the grill operates properly, it is recommended that the island have ventilation on all 4 sides as shown in the following illustration. The ventilation holes should be as diagrammed to ensure adequate ventilation for your grill and island. Natural Gas Conversion Natural Gas Pressure Regulator Location Measurements shown are for attaching the Natrual gas pressure regulator to the enclosure. 20 in.2 (129.0 cm2) min. ventilation both sides 5" (12.7 cm) max. 1½" (3.0 cm) max. 10 in.2 (64.
Refer to the model/serial rating plate for information on the type! of gas that can be used. If this information does not agree with! the type of gas available, check with your local gas supplier. Gas Conversion: No attempt shall be made to convert the grill from the gas! specified on the model/serial rating plate for use with a different! gas type without consulting the serving gas supplier. The! conversion kit supplied with the grill must be used. See “Gas Conversions” section.
REPLACEMENT PARTS 10
Part Number Part (description) Warranty Coverage Quantity Part Number Part (description) Warranty Coverage Quantity 01 Main lid 3 1 31 1 1 02 Main lid screw with screw cover 3 2 Electronic igniter module 32 Rotisserie gas valve 1 1 03 Temperature gauge housing 3 1 33 Main gas valve 1 4 04 Temperature gauge 1 1 34 Igniter junction wire 1 1 05 Main lid handle seat with heat insulating spacer, left 1 1 35 Front baffle 3 1 06 Main lid handle seat with heat insula
INSTALLATION INSTRUCTIONS Unpack Grill Install 20 lb LP Gas Fuel Tank Tray WARNING The tank tray should be secured to a fixed location that can be easily accessed and will allow the gas pressure regulator/ hose assembly to connect to the 20 lb LP gas fuel tank without kinking or putting strain on the gas pressure regulator/ hose assembly. Excessive Weight Hazard Use two or more people to move and install grill. Failure to do so can result in back or other injury. 1.
Grease Cup Bracket Installation Install Grill Place grill into outdoor enclosure, but leave enough room in the back to connect to the gas supply. 1. Loosen and remove the 4 screws preassembled on the grease cup bracket. LP Gas Installation 1. Check that the LP gas pressure regulator/hose assembly is positioned under the grill (as shown in the following illustration) and is not pinched or kinked. 2.
Make Gas Connection NOTE: If grill is to be converted to Natural gas, follow instructions in the “Gas Conversions” section. 20 lb LP Gas Fuel Tank WARNING To Connect the 20 lb LP Gas Fuel Tank: 1. Check that the 20 lb LP gas fuel tank is in the “Off” position. If not, turn the valve clockwise until it stops. 2. Check that the 20 lb LP gas fuel tank valve has the proper type-1 external male thread connections per ANSI Z21.81. 3. Check that the burner control knobs are in the “Off” position. 4.
GAS CONVERSIONS 5. Use an adjustable wrench to remove the LP gas pressure regulator/ hose assembly from the 90° brass adapter. Gas Connection to Natural Gas WARNING A Explosion Hazard Use a new CSA International approved “outdoor” gas supply line. Install a shut-off valve. Securely tighten all gas connections. B Failure to do so can result in death, explosion, or fire. C ! This installation must conform with local codes and ordinances.
3. Connect the quick connector on the other end of the ! 10 ft (3.0 m) PVC flexible gas supply hose to the rigid Natural gas supply pipe (B). A B A A. Main burner orifice A. Brass connector B. Quick connector Change Grill Main Burner Valve Orifices IMPORTANT: Check that the orifice is properly installed inside of the gas valve. 4. Reinsert the burner and reattach using the screw and clip previously removed. Repeat the procedure for each main burner. 5. Position the igniters so they are ¼" (6.
2. Remove the access cover at the back of the grill by removing the 6 screws at the back of firebox. 5. Take out the orifice support, and then use a 6 mm socket and wrench or 6 mm nut driver to remove the LP orifice at the end of the supply pipe. Replace with Natural gas orifice. A B A A. Access cover 3. Using a Phillips screwdriver, remove the screw holding the spider guard to the burner. A. Orifice support B. Orifice IMPORTANT: Check that the orifice is properly installed inside of the supply pipe.
Check and Adjust the Burners The burners are tested and factory-set for most efficient operation. However, variations in gas supply and other conditions may make minor adjustments to air shutter or low flame setting necessary. It is recommended that a qualified person make burner adjustments. NOTE: The rotisserie burner cannot be adjusted. Checking and adjusting the grill burner flames requires removing the grates and flame tamers.
OUTDOOR GRILL USE This manual covers several different models. The grill you have purchased may have some or all of the features listed. The locations and appearances of the features shown here may not match those of your model. Control Panel A B A. Left grill burner control knob B. Left center grill burner control knob C D E D. Rotisserie burner control knob E.Right center grill burner control knob C.
Prepare the Gas Supply Manually Lighting the Main Grill 1. Open the hood completely. Do not light burners with the hood closed. 1. Do not lean over the grill. 2. Remove the manual lighting extension (see following illustration) and attach a match to the split ring. Turn the Gas Supply On 1. For outdoor grills using a 20 lb LP gas fuel tank: ! Slowly open the tank valve. NOTE: If flow limiting device activates, your grill may not light.
Using Your Rotisserie Burner A Rotisserie kit can be purchased as an accessory for the grill. See “Accessories” in the “Assistance” section. To avoid damage to the warming rack, remove from grill when using the rotisserie burner. Do not use the main burners when the rotisserie burner is in use. 5. Push in and turn the control knob to IGNITE/ON. Hold this knob in for 10 seconds after the burner is lit. You will hear the “snapping” sound of the spark until after the knob is released.
ROTISSERIE CHART Use a portable meat thermometer to check internal doneness of the food. Turn off rotisserie burner when meat thermometer reads 5°F/3°C lower than desired internal temperature. Continue rotating, hood closed, for 10 minutes before carving. Timing is affected by weather conditions such as wind and outside temperature.
Grilling Chart ■ Knobs have High, Medium and Low settings for flame adjustment. ■ Heat settings indicated are approximate. ■ Grilling times are affected by weather conditions. FOOD ■ When 2 temperatures are listed, for example: Medium to MediumLow, start with the first and adjust based on cooking progress. ■ Cooking times may vary from chart times depending on the type of fuel, Natural or LP gas. COOKING METHOD/ INTERNAL TEMP.
FOOD COOKING METHOD/ INTERNAL TEMP. BURNER SETTING TIME! (total minutes) SPECIAL INSTRUCTIONS Fillets, Steaks, Chunks! Halibut, Salmon, Swordfish, 8 oz (0.25 kg) ! ! Whole, Catfish, Rainbow Trout, 8-11 oz (0.25-! 0.34 kg) Shellfish, Scallops, Shrimp DIRECT! Medium! 4-6 per ! ½" (1.3 cm) thickness of fish ! ! 5-7 per side! ! Grill, turning once. Brush grill with oil to keep fish from sticking. Remove when inside is opaque and flaky with skin easily removed.
OUTDOOR GRILL CARE GRILL GRATES Replacing the Igniter Battery If igniters stop sparking, the battery should be replaced. 1. Unscrew igniter button cap counterclockwise to remove. B A IMPORTANT: To avoid damage to grill grates, do not use a steel or fiber scraper. Immediately after you are finished cooking, loosen food soil with a brass bristle brush. Turn all burners to HI for 10-15 minutes with the hood closed to burn off food soil. Turn off all burners, raise the hood and let grates cool.
BURNERS ROTISSIERE BURNER Cleaning Method: Clean the exterior of the burner with a wire brush. ■ ■ Clear any clogged burner ports with a straightened paper clip. ■ Do not use a toothpick as it may break off and clog the port. ■ Check and clean burner/venturi tubes. 1. Remove grill grates and flame tamers. 2. Remove the screw and clip that hold the burner in place. Remove gas burner from the grill. Cleaning Method: 1. Light the rotisserie burner. See the “Using Your Rotisserie Burner” section. 2.
TROUBLESHOOTING Grill will not light ■ Is the 20 lb LP gas fuel tank valve turned off?! Turn the 20 lb LP gas fuel tank on. ■ Is the grill properly connected to the gas supply?! Contact a trained repair specialist or see Installation Instructions. ■ Is there gas in the 20 lb LP gas fuel tank?! Check the gas level. Is the igniter working?! Check that the igniter battery is properly installed or check to see if the battery needs to be replaced. See the “Replacing the Igniter Battery” section.
LIMITED WARRANTY Nexgrill warrants to the original consumer-purchaser only that this product (Model #740-0780) shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated below beginning on the date of purchase. The manufacturer reserves the right to require photographic evidence of damage, or that defective parts be returned, postage and or freight pre-paid by the consumer, for review and examination.
Neither dealers nor the retail establishment selling this product has any authority to make any additional warranties or to promise remedies in addition to or inconsistent with those stated above. Manufacturer's maximum liability, in any event, shall not exceed the documented purchase price of the product paid by the original consumer. This warranty only applies to units purchased from an authorized retailer and or re-seller.
