5KSM3311 W10747072C_01_EN_v06.
ENGLISH TABLE OF CONTENTS PARTS AND FEATURES �����������������������������������������������������������������������������������������6 STAND MIXER SAFETY �����������������������������������������������������������������������������������������7 Important Safeguards �������������������������������������������������������������������������������������7 Electrical Requirements ����������������������������������������������������������������������������������9 Electrical Equipment Waste Disposal �������������
PARTS AND FEATURES PARTS AND ACCESSORIES Attachment hub Motor head Beater shaft Flat beater Speed control Bowl Wire whip Dough hook Flex Edge beater* Pouring shield* 6 | PARTS AND FEATURES W10747072C_01_EN_v06.
wl ENGLISH STAND MIXER SAFETY IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all instructions. Misuse of appliance may result in personal injury. 2. To protect against risk of electrical shock, do not put Stand Mixer in water or other liquid. 3. Unplug the Stand Mixer from outlet when not in use, before putting on or taking off parts, and before cleaning. 4.
STAND MIXER SAFETY 5. This appliance is not intended for use by persons, including children, with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instructions concerning use of the appliance in a safe way and understand the hazards involved. 6. The appliance is not to be used by children. The appliance and cord should be out of reach of children. 7. Avoid contacting moving parts.
ENGLISH STAND MIXER SAFETY 14. This appliance is intended to be used in household and similar applications such as: - staff kitchen areas in shops, offices or other working environments. - farm houses. - by clients in hotels, motels and other residential type environments. - bed and breakfast type environments. SAVE THESE INSTRUCTIONS ELECTRICAL REQUIREMENTS Voltage: 220-240 V Frequency: 50-60 Hz Wattage: 250 Watts NOTE: The power rating for your Stand Mixer is printed on the serial plate.
STAND MIXER SAFETY ELECTRICAL EQUIPMENT WASTE DISPOSAL Disposal of packing material The packing material is 100% recyclable and is marked with the recycle symbol . The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal. Scrapping the product - This appliance is marked in compliance with European Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE).
ENGLISH USING THE STAND MIXER SPEED CONTROL GUIDE All speeds have the Soft Start® feature which automatically starts the Stand Mixer at a lower speed to help avoid ingredient splash-out and “flour puff” at start-up, then quickly increases to the selected speed for optimal performance. NOTE: The speed control can be set between the speeds listed in the chart to obtain speeds 1, 3, 5, 7, and 9 if a finer adjustment is required.
USING THE STAND MIXER ASSEMBLING THE STAND MIXER 1 Check to be sure that the Stand Mixer is unplugged, and the speed control is turned to “0”. 2 Raise the motor head: Slide the locking lever to the unlock position and lift the motor head. Once lifted, slide the locking lever to the lock position to keep the motor head up. 4 Attach any accessory: Slip the accessory onto the beater shaft and press upward as far as possible.
5 ENGLISH USING THE STAND MIXER Lower the motor head: Slide the locking lever to the unlock position and guide the motor head down. Make sure motor head is completely down, then slide the locking lever to the lock position. Before mixing, test lock by attempting to raise the motor head. (OPTIONAL) To adjust beater to bowl clearance: Tilt the motor head back; then turn the screw slightly counterclockwise (left) to raise the beater, or clockwise (right) to lower the beater.
USING THE STAND MIXER OPERATING THE STAND MIXER NOTE: The Stand Mixer may warm up during use. Under heavy loads with extended mixing time, the top of the unit may become hot. This is normal. Electrical Shock Hazard Plug into an earthed outlet. Do not remove earth prong. Do not use an adapter. 1 Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Plug the Stand Mixer into an earthed outlet.
NOTE: The pouring shield* can be used to avoid ingredients splashing out of the bowl when mixing as well as to easily pour ingredients in the bowl while mixing. ENGLISH USING THE STAND MIXER (OPTIONAL) Pour ingredients into the bowl through the pouring chute. DISASSEMBLING THE STAND MIXER 1 Raise the motor head: Check to be sure that the Stand Mixer is unplugged, and the speed control is turned to “0”; then slide the locking lever to the unlock position and lift the motor head.
USING THE STAND MIXER 2 Remove the accessory: Turn the speed control to “0”, unplug the Stand Mixer, and tilt the motor head back; then, press the accessory upward as far as possible, then turn the accessory clockwise and pull it away from the beater shaft. 3 Remove the bowl: Gently turn the bowl counterclockwise to release it from the bowl clamping plate.
3 Insert attachment into attachment hub, making certain that attachment power shaft fits into the square attachment hub socket. It may be necessary to rotate the attachment back and forth. When it is in the proper position, the pin on the attachment will fit into the notch on the hub rim. 4 ENGLISH USING THE STAND MIXER Tighten the attachment knob by turning it clockwise until the attachment is completely secured to the Stand Mixer.
CARE AND CLEANING 3 The wire whip is not dishwasher safe. Clean it thoroughly in hot, sudsy water and rinse completely before drying. Do not store the wire whip on the shaft. TROUBLESHOOTING 2. The Stand Mixer may emit a pungent odor, especially when new. This is common with electric motors. 3. If the flat beater hits the bowl, stop the Stand Mixer. See the “Assembling the Stand Mixer” section and adjust the beater to bowl clearance. 4.
ENGLISH WARRANTY AND SERVICE KITCHENAID STAND MIXER WARRANTY Length of Warranty: KitchenAid Will Pay For: KitchenAid Will Not Pay For: Europe, Middle East and Africa: 5KSM3311 Five years full warranty from date of purchase. The replacement parts and repair labour costs to correct defects in materials or workmanship. Service must be provided by an Authorised KitchenAid Service Centre. A. Repairs when Toaster is used for operations other than normal household food preparation. B.
©2017 All rights reserved. Specifications subject to change without notice. W10747072C W10747072C_19_Back.