Installation Instructions/Use and Care Guide Hot Water Dispenser Important: Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions with homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use. Part No.
Before you start... Check location where hot water dispenser will be installed. Proper installation is your responsibility. Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with installation specifications provided and with state and local plumbing codes. Electrical Shock Hazard Special care must be taken when drilling holes into walls or water pipes. Electrical wires may be concealed behind the wall covering or water may remain in pipes.
Tools and materials needed for installation: Electrical Shock Hazard l Electrical ground is required on this appliance. l If cold water pipe is interrupted by plastic, non-metallic gaskets or other insulating materials, Do Not use for grounding. l Do Not ground to a gas pipe. l Do Not modify the power supply cord plug. If it does not fit the outlet, have a proper outlet installed by a qualified electrician. l Do Not have a fuse in the neutral or grounding circuit.
Installation Turn off main water supply. Turn on sink cold water faucet and allow all water to drain from line. Turn off faucet. With hot water dispenser in kitchen. I 1 Determine the best faucet mounting position that will allow faucet spout to empty into sink. Check below sink to assure that reinforcing ribs, support brackets or cabinet construction will not interfere with faucet mounting. Knock out plug from hole in sink or cut a hole in sink or countertop.
Numbers correspond to steps. green tape tubing faiket I4n Push or pull faucet lever to open position. Hold lever in open position I 1 until tank is full (approximately 1 len tank is full. water will flow from faucet spout. Release lever to close faucet. Check for leaks. BIcm saddle valve II 111I Turn saddle valve handle clockwise until lance pierces soft copper tubing u and valve is firmly seated: The valve is now in the closed position. Place a bucket under open end of water supply line.
Use and care information For short periods (2-30 days) of nonuse: Set the hot water dispenser thermostat to the “OFF’ position to conserve energy. If you have very hard water, it may be necessary to occasionally clean the faucet screen to remove sediment buildup. Your hot water dispenser uses a heating element to warm water in the tank to approximately 190°F when the temperature control is turned to the highest position. You can draw approximately 2 quarts of hot water at a time.
Km~he~Aid%stant-Iiot’VVater LENGTH OF WARRANTY ONE YEAR FULL WARRANTY FROM DATE OF INSTALLATION. KITCHENAID WILL PAY FOR: Replacement parts and repair labor to correct defects in materials or workmanship. Service must be provided by a KitchenAid-authorized servicing outlet. Dispenser Warranty KITCHENAID If you need service... WILL NOT PAY FOR: In the event that your KitchenAid appliance should need service, call the dealer from whom you purchased the appliance or a KitchenAidauthorized service company.