2.4GHz Digital Transmission system Manual V1.
Receiver: Operating Frequency Band 2. GHz Receiver Sensitivity -DBMS min. Video Output Level 140 ohm Audio Output Level 140 2 p-p @ ANN ahm (STARFRUIT) Antenna Unidirectional Power consumption 1.8W Power supply SW 1A Dimension Female 3m 24mm Weight 82g Digital wireless cameras: Operating Frequency Band 2 Maximum Transmit Power 100m Modulation TEGAM/GPSKIBPSK Antenna Unidirectional Power consumption 1.
G.Troubleshooting Problems. Possible Solution Check all cable conned ions. Make sure power plugs are pushed all the way in Check power switches on the remote TW or DVR and Video source{Camera, Ca moo der, slo} Na picture ar sound | secy if the POWER LED of the neurotransmitter vireo ss tantra ane rec ier Their LINK LED should be it Portent? If Their LINK LED should not be lit, you must re-pair their codes following the D. instruction of the manual Adjust receiver and interdepartmental wireless 3.
Please note: Pressing the pairing buttons for transmitter'digital wireless camera and receiver is not necessary at the same time, and they are not necessarily put near or side by side in pairing status, around within 3 meters far is GK. Under the transmission, you can see the strength on the monitor as below: i] ie F.Use No tics 1.
For digital wireless camera Front view Back view Pairing button inside D. Transmitter and Receiver Wire Connection Transmittal) AoA Camera name Revere A Sip, ve! ae SURE Fae BE.Pairing the transmitter and receiver When you get the trans mitt digital wireless cameras ar receiver, yau must pair them before use it, fallowing the instructions as below 1.