Specification Sheet

DESCRIPTION
SPECIFICATIONS
*Power will vary depending on the SDRAM used.
KVR24N17S8/8
8GB 1Rx8 1G x 64-Bit PC4-2400
CL17 288-Pin DIMM
Continued >>
FEATURES
This document describes ValueRAM's KVR24N17S8/8 is a 1G x 64-bit
(8GB) DDR4-2400 CL17 SDRAM (Synchronous DRAM), 1Rx8,
memory module, based on eight 1G x 8-bit FBGA components. The
SPD is programmed to JEDEC standard latency DDR4-2400 timing of
17-17-17 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The
electrical and mechanical specifications are as follows:
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
17 cycles
45.75ns(min.)
350ns(min.)
32ns(min.)
TBD W*
94 V - 0
0
o
C to +85
o
C
-55
o
C to +100
o
C
• Power Supply: VDD=1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD=2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Single-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• PCB: Height 1.23” (31.25mm)
• RoHS Compliant and Halogen-Free
Document No. VALUERAM1537-001.A00 05/24/16 Page 1
kingston.com
Memory Module Specifi cations