P-Trap Installation: 4. Waste Cover = 6. Horizontal Leg 1. Slip Joint Nu 2. Black Washer 7. Bottle Trap 3. Slip Joint Nut D 5. Black Washer Remove horizontal leg and slip joint nut from bottle trap. Apply Teflon tape to all exposed threads. Insert slip joint nut (3) and waste cover {4) onto horizontal leg (6). Insert horizontal leg into wall waste opening, do not tighten. Insert black washer (2) and slip joint nut (1)onto tail piece (8).
FAUCET INSTALLATION INSTRUCTIONS Need Tools: Console Sink Sets Before Installation : 1. Before beginning the installation of your console pedestal basin, it is important to identify the type of wall where the pedestal will be installed and prepare the installation location accordingly. 2. Install an anchoring brace in the wall prior to installing the drywall, this can piece of wood that will fit between the two studs, then install drywall and finish as usual.
Installation Step : 8 Basin's Mounting Holes Wall Bracket Location 9 Mounting Holes r Basin Q\Z racket Holes o Bracket o Anchor Wood Screw . Carefully place the basin on the fop of leg support assembly with its back against the wall. Then place the basin supporting bracket to the fiat edge under the basin. Mark the location of the basin's mounting holes and the location of drill holes for the bracket. . Remove basin, drill the mounting holes and holes for bracket.
KINGSTON KILOHERTZ R Bath Toggle Bolt Anchor Installation Instructions: 1. 2. If you are installing on a plaster (Drywall) wall we recommend using toggle bolt anchors (include, drill a 5/8” hole at the marked location of the holes Remove toggle from bolt, insert washer on the bolt and insert bolt through the basin mounting holes.