Parts List For Delta Universal Trim Kit A ‐ Sleeve B ‐ Large Sleeve C ‐ Dome Nut D ‐ Adjusting Ring F ‐ Faceplate Insert G1 ‐ Foam Insert H ‐ Faceplate Insert G2 ‐ Foam Insert E ‐ Faceplate I ‐ Diverter Plug J ‐ Diverter Foam K ‐ M6 × 1.
Installation Instructions for Delta Universal Trim Kit Removal of Old Trim (figure 1) 1. Shut off water supply to tub/shower faucet. This may require shutting off the main water supply. Once water supply is off, turn on the faucet to allow the release of any water pressure. 2. Remove the handle cap from the old handle. Remove retaining screw and handle. 3. Note which valve type is being used (figure 2). Note whether the valve uses a diverter. 4. Remove dome nut assembly.
Installation Instructions for Delta Universal Trim Kit Handle Adapter for Valve Types A or B (figure 8) 1. Locate handle adapters for valve type A & B. Determine which adapter to use based on which will fit on valve stem. 2. Partially thread set screw into handle adapter that fits on the valve stem (figure 8). 3. Slide handle adapter onto valve stem, making sure that the valve stem is fully seated in the adapter. Align the handle adapter to where the set screw is pointing down.