Aqua Eden ELEMENTS OF DISTINCTIVE STYLE Cast Iron Bath Tub Installation Parts: Bolts 4 Pcs 4 Pcs www laughingstock TOLL-FREE CUSTOMER SERVICE: 1-877-2-BRASS TECHNICAL SUPPORT E-mail: 12775 Reservoir Street, Chino, CA 91710 TOOLS REQUIRED = N Adjustable Wrench Rubber Mallet [ Mark location « [the tub drain is located in the center, please install the tub feet pointing in a more horizontal position (Fig 1).
10 YEAR MANUFACTURER'S LIMITED WARRANTY Al parts of this Kingston Brass faucet are warranted to the original retail purchaser to be free from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser’s receipt. This warranty is limited to defective parts only, labor charges and/or damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
Need Tools: KINGSTON o INSTALLATION INSTRUCTIONS =0 % S Wall Mount Tub Filler BEFORE BEGINNING INSTALLATION: 1. Flush plumbing lines to clear any debris. 2. Shut off both supply lines after flushing. 1 2] Basin Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver o & SuS SRR Shut off hot and cold water supply under 2. Install the spout on top of faucet body. 5. Connect water supply shank to hot and 6. Tum on water supply valves and check for sink.
Parts: Nt (Cold Cartridges: KSRFT1000CC| @ Hot Handle: CCMX1H © Cold Handle: CCMX1C CARE AND MAINTENANCE OF YOUR FAUCET Your Kingston Brass faucet has been finished to the most strict standards, however, due to the high content of minerals in the water, your finish may appear dull and famished after time. ese are some do's and don'ts to maintain the luster on your faucet for many years to come. DO 1. Uso a silicon based caulking when installing. 2. Clean your faucet with only a mild soap and water solution.
KINGSTON KITCHEN & BATH www.kingstonbrass.
KINGSTON KITCHEN Ba Bath INSTALLATION INSTRUCTIONS Brass Tub Bath Drain Note: Observe all local plumbing and building codes. TOOLS REQUIRED Drain Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver Pipe Wrench INSTALLATION INSTRUCTIONS: 1. Place rubber washer (10) onto waste tube (9} and set them under the tub. 2. Apply Teflon tape on strainer thread and a bead of silicone Rubber Gasket (3) " sealant under waste strainer (11) and thread into waste Cover Plate (2) Ny tube (9).
KINGSTON KITCHEN R BATH Single Offset Bath Supply Installation Parts: Cane Washer & Cone Washer & Coupling Nut & | Coupling Nut & Friction Ring | Friction Ring | NPS) PCs PCs 4 Pcs www laughingstock TOLL-FREE CUSTOMER SERVICE: 1-877-2-BRASS TECHNICAL SUPPORT E-mail: 12775 Reservoir Street, Chino, CA 91710 Escutcheon Before starting the installation: Straight supply lines are designed to ba installed on tubs that are configured for deck mount faucets, and should be installed at the same center to center dist