wr KINGSTON LIMITED WARRANTY All parts of this Kingston Brass faucet are warranted to the original retail purchaser to be free KITCHEN & BATH from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt.
KINGSTON RUCHED & HATS INSTALLATION INSTRUCTIONS Tub Wall Mount Tub Filler with Hand Shower 3 This faucet is to be installed on the wall of your tub, if your faucet needs to be installed on your bathroom wall, please change for model KS2686. BEFORE BEGINNING INSTALLATION: 1. Flush both supply lines to clear any debris Need Tools: F=f) Ca [ny =e Basin Wrench Adjustable Wrench ~~ Teflon Tape Silicone Sealant Screwdriver 2. Shut off both supply lines after flushing. 1 giv Washer Er Elbow ey 1.
( Parts: Replacement Parts Hot Handle: KSHATRIYA QL) i Cold Handle: KSH266C CARE AND MAINTENANCE OF YOUR FAUCET Your Kingston Brass faucet has been finished to the most strict standards, However due to the high content of minerals in the water your finish after time may appear dull and famished, these are some do's and don'ts to maintain the luster on your faucet for many years to come. 1. Clean your faucet with only a mild soap and water solution. 2. Dry your faucet after using it. | 3.
KINGSTON KITCHEN & BATH www.kingstonbrass.
KINGSTON HITCHER 8 BATH INSTALLATION INSTRUCTIONS Brass Tub Bath Drain Note: Observe all local plumbing and building codes. TOOLS REQUIRED Drain Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver Pipe Wrench INSTALLATION INSTRUCTIONS: 1. Place rubber washer (10) onto waste tube (9) and set them under the tub. 2. Apply Teflon tape on strainer thread and a bead of silicone Rubber Gasket (3) sealant under waste strainer (11) and thread into waste Cover Plate (2) tube (9).
KINGSTON KITCHEN BATH Double Offset Bath Supply Before starting the installation: Straight supply lines are designed to ba installed on tubs that are configured for deck mount faucets, and should be installed at the same center to center distance as that of the tub faucet holes, the supply lines should be installed in a plumb vertical position before starting the installation we recommend: © That you have the supply lines and faucet at the job site prior to preparing the rough-in water: "Suppl.
KINGSTON KITCHEN & BATH INSTALLATION INSTRUCTIONS Straight Stop Instructions: Apply thread sealant tape to threads (1). Screw valve body (2) onto pipe (3). Place nut (4), metal washer (5) and rubber washer (6) on tube (7). Insert tube (7) into valve. Wrench tighten nut (4) onto valve. Stop any leaks by tightening nuts slightly. ooh wn ~No on www.kingstonbrass.