Users Manual
TW S E A
Handsfree
10MRanges
User Quick
R P H O N E
SupportSiri
Light
Touch Button
HOW TO POWER ON AND PAIR THE EARPHONES
Guide
Light
Transmission distance: 10M
Earphone battery: 40mAh
Charge box capacity: 400mAh
Work time: 3-4hour
Charging time: 1-2hour
Charging case voltage: 5V
1. Charge with the charging dock, The white light flashin g .
2. The earp h o ne is charg ing an d p o w ers o ff, Th e red lig h t.
CHARGING STATE
1. When the earphones are removed from the charging case,
they will automatically turn on and pair to each other automati
cally.
2. Bluetooth pairing name: k023
3. When using the earphones later, it will automatically
connect to the phone.
4. Earphones will automatically turn off if there is not connected to
phone after 5 minutes.
PRODUCT PARAMETERS
Power on
HOW TO USE (TOUCH BUTTON)
Power off
Long press the touch 2s
Long press the touch 3s
Play/Pause One click
Long press the touch 1s
SIRI
Answer the call
One click
Refuse the incoming call
Long press the touch 1s
Hang up the call
One clickCancel the dial
Power on
Power off
Long press the touch 2s
Long press the touch 3s
Play/Pause One click
Touch Button(Right Earphone)
Touch Button(Left Earphone)
Volume -
Previous song Double clicks
Three clicks
One click
Answer the call
One click
Refuse the incoming call
Long press the touch 1s
One clickCancel the dial
Volume +
Next song
Hang up the call Double click
Three clicks
Double clicks
W
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
FCC ID: 2AO47K023