User's Manual

2.4G Wireless Module

USER MANUAL

2.4G-01 MODEL

Summary

2.4G wireless key control module works in fitness equipment or other

equipment requiring wireless control, with strong anti-interference and

automatic matching function.

The module is divided into transmitting and receiving, which can realize the

function of two switches, and has the function of pairing and electric quantity

indicating.

TX function overview

1. When pairing, press the keys 1 and 2 at the same time, and enter the pairing

mode for 30 seconds, until the LED flashes normally, then the receiver is

powered on, and the transmitter is close to the receiver, if pairing is

successful. If the pairing is not successful within 60 seconds, exit the

broadcast pairing function.

2. When the battery voltage is lower than 2.7V, the transmitter sends the

identification code to Rx.

When the battery voltage is lower than 2.4V, the LED at the transmitter flashes

every second.

TX technical parameters

Supply voltage DC2.5V~3.3V

PAGE 1
2.4G Wireless Module USER MANUAL 2.4G-01 MODEL Summary 2.4G wireless key control module works in fitness equipment or other equipment requiring wireless control, with strong anti-interference and automatic matching function. The module is divided into transmitting and receiving, which can realize the function of two switches, and has the function of pairing and electric quantity indicating. TX function overview 1.
PAGE 2
Working peak current 18MA Standby current 5uA working temperature -20~80℃ Pairing frequency 2.4G Normal operating frequency 2.4G modulation mode GFSK Module size TX13*25MM FCC regulatory compliance statement §15.19 Statement This device complies with Part 15 of the FCC Rules.
PAGE 3
Please notice that if the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the following: contain FCC ID: 2AWGP24G-01MODEL ” any similar wording that expresses the same meaning may be used. § 15.19 Labelling requirements shall be complied on end user device.