User Manual

ManualsBrandsKING PROFIT TRADING ManualsElectronicsPORTABLE SOUND SYSTEM

Table Of Contents

PORTABLE SOUND SYSTEM

INSTRUCTION MANUAL

Model：KP626BT

TY-ASC40

IMPORTANT

: Please read before using and keep for future reference.

Summary of content (12 pages)

PAGE 1
INSTRUCTION MANUAL PORTABLE SOUND SYSTEM Model：KP626BT TY-ASC40 IMPORTANT: Please read before using and keep for future reference.
PAGE 2
IMPORTANT NOTES INTRODUCTION  Thank you for buying this product.  Please read through these operating instructions, so you will know how to operate your equipment properly. After you finished reading the instructions manual, put it in a safe place for future reference. CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, DO DOT REMOVE THE COVER (OR BACK). DO NOT OPEN THE UNIT. FOR SERVICE, PLEASE REFER TO QUALIFIED SERVICE PERSONNEL.
PAGE 3
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. additional Warnings and Precautions • CAUTON: To PREVENT ELECTRIC SHOCK, MATCH WIDE NLADE OF PLUG TO WIDE SLOT, FULLY INSERT. • mains plug is used as disconnect device and it should remain readily operable during intended use.
PAGE 4
• Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. • If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. • Do not mix old and new batteries. • Completely replace all old batteries with new ones. • Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
PAGE 5
product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol indicates that this product incorporates double insulation between hazardous mains voltage and user accessible parts. WARNING: - Remove batteries if exhausted or if they will not be used for a long period. - The incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. Therefore: - Do not mix battery types, e.g.
PAGE 6
PAGE 7
IC Notice: This device complies with Canada Industry licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference. and (2) this device must accept any interference. Including interference that may cause undesired operation of the device.
PAGE 8
LOCATION OF CONTROLS NAMES OF CONTROLS 1. DISPLAY 2. PAIR INDICATOR 3. CHARE INDICATOR 4. P-MODE/MEM BUTTON 5. /TUN.- BUTTON 6. LIGHT BUTTON 7. FOLDER/10/M. - BUTTON 8. PLAY/PAUSE/PAIR/SCAN BUTTON 9. /TUN.+ BUTTON 10. POWER SWITCH 11. FUNCTION BUTTON 12. FOLDER/10/M. + BUTTON 13. VOLUME KNOB 14. GUITAR VOLUME KNOB 15. TREBLE KNOB 16. BASS KNOB 17. MIC ECHO KNOB 18. MIC VOLUME KNOB 19. USB PORT2 20. 6.3MM MIC JACK 21. 6.3MM GUITAR JACK 22. 3.5MM AUX IN JACK 23. USB PORT1 24. HANDLE 25. TWEETER 26.
PAGE 9
ADJUSTING THE VOLUME 1. Rotate the VOLUME knob on the unit to increase or decrease the music volume. 2. Rotate the GUITAR VOL. knob on the unit to increase or decrease the guitar volume. 3. Rotate the MIC VOL. knob on the unit to increase or decrease the microphone volume. BASS ADJUSTMENT Rotate the BASS knob on unit to increase or decrease the bass effect that best matches the music style.
PAGE 10
2. Press the P-MODE/M. button. “P01 ” will flash on the display to indicate that you are saving the station as Preset Memory 01. (To change the preset memory number, press the FOLDER/10/M. + or FOLDER/10/M. - buttons.) 3. Press the P-MODE/M. button to finish saving the station (e.g., P01 is now set to 93.1). 4. To save another station, repeat steps 1 to 3. You may save up to 30 FM stations USB OPERATION This unit provides two USB port for music playback. 1.
PAGE 11
Press the P-MODE/M. button on unit in play mode till the “RAND” shows steadily on the display, the random play will start from next track automatically. Press the P-MODE/M. button on unit again until the “RAND” disappears from the display to cancel. BLUETOOTH OPERATION 1. Press the FUNCTION button on unit to switch to BLUETOOTH function, the LCD will display “bt” and the pair indicator will flash at high speed. 2.
PAGE 12
SPECIFICATIONS GENERAL Power Requirement ........................................... AC100-240V 60/50Hz Power consumption ....................................................................... 30 W Weight-------------------------------------------------------------------------5.1kg Dimensions ............................................ 202(L) x 201(D) x 490 (H) mm Operation temperature ............................................ + 5°C – + 35° C AUDIO SECTION Power output ................................