X-Tag - User Manual
Table of Contents 1 KINEXON X-Tag..............................................................................................................................................5 2 KEYFACTS ........................................................................................................................................................6 3 SPECIFICATIONS............................................................................................................................................7 3.
KINEXON GmbH Schellingstr. 35 80799 München Tel.: +49 (0)89 / 200 61 65-0 info@kinexon.com http://www.kinexon.com This document contains information that is the property of Kinexon GmbH. Reproduction is not permitted without the express written consent of the author. (info@kinexon.com). If you have any questions or suggestions concerning this document, please send the problem description by mail to KINEXON GmbH.
THE KINEXON X-Tag 4
1 KINEXON X-Tag Cost efficient and precise real-time localization & motion sensing. The KINEXON X-Tag is the perfect sensor for indoor localization in industrial and logistics environments. Use Cases Track & Trace and optimized material handling of moving assets in industrial environments such as: By mounting or embedding the tag on the object, it enables a precise and robust localization of all assets on the shop floor.
2 KEYFACTS RF Specifications Positioning Principle Real Time Location System (RTLS), Radio-based, Ultra-wideband (UWB) Frequency range UWB (IEEE 802.15.4): 6.25 – 6.75 GHz Positioning Update rate Configurable, typically 1 Hz in motion, 0.033 Hz in standstill Positioning Data 3D (x, y, z) Positioning Accuracy < 20 cm (depending on environment), MAE Physical Specifications Indicators Status LED Inertial Measurement (Accelerometer) 3-axis, +/- 0.
3 SPECIFICATIONS 3.1 Mechanical Drawing 3.2 Label front plate Company logo Equipment Unique Identifier (EUI) QR code 3.2.
QR code Compan y logo Certification logos/signs Size: (23x55) mm 3.3 External interfaces 3.3.1 Wireless connection For wireless connection a Ultra-Wideband (UWB) interface according to IEEE 802.15.4 is implemented. 3.3.2 Tag LED Please mind that tag LED behavior depends on the firmware use case one has selected. Most important versions are: Power-on Reset Color Duration Explanation yellow Constant, ~1s Standstill (sleep) mode - The LED is blinking every 30 seconds for approximately 1s.
Interface Parameter Min Typical Max Comment [ Unit] Input Current [mA] 250 mA UWB receive 3.4 Battery A Lithium Polymer re-chargeable battery is used Type CP502440 Nominal Voltage 3.0V Capacity 1200 mAh Operating temperature discharge -20°C to +60°C Size 40.5mm x 24.5mm x 5.2mm 3.5 Accessories 3.
3.9 Intended Use This manual describes the setup and use of the Kinexon X-Tag. Use this product only for the purpose it was designed for. 3.10 FCC Compliance This device complies with 47 CFR Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Les appareils ne peuvent pas être utilisés à bord d'aéronefs ou de satellites et ils ne peuvent pas être utilisés pour faire fonctionner des jouets. L'utilisation de cet appareil monté sur une infrastructure fixe d’extérieur, comprenant les antennes montées sur des structures externes telles que des poteaux ou des bâtiments, n’est pas autorisée, sauf lorsque les structures en question sont des bateaux ou des véhicules terrestres. 3.
