Instruction Manual

Contents
-RC Vehicle (Vehicle) x 1
-RC Transmitter (Transmitter ) x 1
-Water pump x1
-Drifting wheels x4
-Screwdriver x1
-Instruction Manual x 1
-6.4V Rechargeable Battery Pack x 1
-USB charging cable x 1
-9V Battery x 1
1. The 6.4V rechargeable battery pack must be charged before use by utilizing
the USB charging cable which included
2. Do not overcharge the battery pack. Do not charge for more than 6 hours
3. Do not charge the battery pack if it shows leakage, corrosion, or has loose or
exposed wires or other damage
4. Do not cover the battery pack with any sort of materials while charging
5. Do not touch the battery pack when it is hot. Wait until the battery pack cools
before installing it in the Vehicle and before recharging
6. Do not dispose of the battery in fire
7. Do not dismantle the battery or charger, and do not cut the battery or USB
charging cable
8. The battery pack will be warm after charging, and hot after use in a vehicle
9. The supply terminals are not to be short-circuited
10. Rechargeable batteries are to be removed from the toy before being charged
11. Rechargeable batteries for adult charging only
12. Battery replacement must be only made by adults
13. The USB charging cable is not a toy
14. Charge only type (1300mAh Max.) rechargeable battery packs. Other types of
batteries may burst causing injury to persons and damage. This power unit is
intended to be correctly orientated in a vertical or floor mount position. This
USB charging cable is intended to be used for charging 6.4V rechargeable
battery pack with capacity 1300mAh Max. It cannot be used for charging
non-rechargeable batteries. Regular examination of USB charging cable for any
damage to their cord, plug, enclosure and other parts, and that, in the event of
such damage, it must not be used with the USB charging cable or battery pack
charge until such damage has been repaired. Note that the 9V battery is
non-rechargeable and is not to be recharged. Only batteries of the same or
equivalent type as recommended are to be used. It will need replacement when
transmission is poor.
15. Exhausted batteries are to be removed from the product.
Battery Installation
For Transmitter (Fig. 3 and Fig. 4)
1. Unscrew the screw on the battery cover
2. Open the battery cover
3. Install 1 new 9V battery with correct polarities (+/-) as shown inside the battery
compartment
4. Close the battery cover
5. Tighten the screw on the battery cover
For Vehicle (Fig. 1 and Fig. 2)
1. Switch OFF the power
2. Unscrew the screw on the battery cover
3. Open the battery cover
4. Install 6.4V battery pack with correct polarities (+/-)
as shown inside the battery compartment
5. Close the battery cover
6. Tighten the screw on the battery cover
Vehicle - Battery Installation
Vehicle
Transmitter
Transmitter - Battery Installation
ages
8
PRO. SYSTEM
1:14
SCALE
LIGHTING
EFFECT
1 X 9V Battery
For Transmitter
(Included)
9V
6.4V
1300mAh
For Vehicle
(Included)
6.4V
RC Vehicle x 1
Water pump x1
Screwdriver x1
Drifting wheels x4
RC Transmitter x 1
25M / 82FT
RANGE
25M / 82FT
Screwdriver x1
Fig. 1
Fig. 4
I
+
9 V
Battery
Fig. 3
LED Battery
Indicator
Steering
Wheel
ON/OFF
(At Rear)
Accelerator
Trigger
KIDZTECH TOYS
MADE IN CHINA
ON
OFF
L
R
Mustang GT4
Direction
Adjustment
Battery
Compartment
ON/OFF
Fig. 2
KIDZTECH TOYS
MADE IN CHINA
ON
OFF
L
R
6.4V
Mustang GT4
1. Turn on the Vehicle.
2. Keep pulling the trigger of the Transmitter forward then turn the Transmitter on. Do not release the trigger until the binding process completed.
3. The LED light of the Transmitter will keep flashing for the binding process, which is within 8 seconds. Do not turn off any buttons while in progress, otherwise,
the process will be terminated.
4. After the wheels of the Vehicle turn left and right and the LED light of the Transmitter stops flashing, the binding process completed for playing.
5. If it cannot complete within 8 seconds, please turn off both Vehicle and Transmitter and re-start the binding process.
6. When the binding process is done, whenever switching the Vehicle and Transmitter on and off, it searches for the code that it memorized, and will only lock on to
the Transmitter signal containing that code.
7. Please turn off both Vehicle and Transmitter and re-start all binding process if changing to another 2.4GHz Transmitter for playing.
How To Bind
How To Play
How To Fill In Water For Smoking Effect
4. Close the cap firmly. (Fig.8)
3. Fill in clear water to vehicle by using the provided
water pump. (Fig.7)
2. Open the cap of water tank on the vehicle. (Fig.5 and Fig.6)
1. Fill in clear water into the water pump.
Water tank cap
Fig. 5
Fig. 7 Fig. 8
Fig. 6
3. Use the Accelerator Trigger to drive the Vehicle Forward, Stop and Backward
4. If the vehicle does not run in straight line, adjust the
Direction Adjustment on the Vehicle chassis
5. Play on smooth surface to have the optimum performance
6. Remember to switch OFF the power of the Vehicle and
Transmitter after playing
7. The optimum control range is up to 25m(82ft) outdoor
1. Switch ON the Vehicle and Transmitter.
Turn Left Turn Right
2. Use the Steering Wheel to control the Vehicle turning left or right
KIDZTECH TOYS MADE IN CHINA
ON
OFF
L
R
Mustang GT4
Vehicle
Forward
Stop
Backward
Transmitter
Charging the Rechargeable Battery Pack for the Vehicle:
1. Connect the 6.4V rechargeable battery pack to USB charging cable
2.
Plug the USB charging cable into the standard AC socket (the equipment of class II or class III)
3. The charging time for a full charge is about 3 hours
4. When charging is completed, unplug the USB charging cable
5. Disconnect the rechargeable battery pack from the USB charging cable