Installation Instructions
The Car requires one 3.7V rechargeable battery (included ). Not Replacable.
The controller requires two AA 1.5V batteries(not included).
When changing batteries,adult supervision is required.
Use alkaline batteries for best performance.
The car and the remote controller must be paired before operation
1.Turn the ON/OFF switch to the ON position, the car will light up.
2.Press the button on the remote controller (after batteries are installed).
3.If you have more than one set of car and controller, pair them one at a time.
4.Playing two cars at the same time is not recommended. They may cause interference with each
other.
Do not operate during thunderstorms or rain.
Avoid Water,sand and snow when operating car.
Do not submerge car or controller in water.
Never operate you car in a conned or crowded area and do not use people or
animals as obstacles.
Do not run car into furniture,objects or hard surfaces,as this will cause damage to
both the objects and you car.
Keep ngers,hair and loose clothing away from the tires,gears and motor while
the car is switched on.
Do not leave car or remote controller near source of heat or under direct sunlight
for long periods of time.
Do not leave car or remote controller outside overnight,dampness is harmful to
interior components.
Remove all batteries when not in use to avoid accidental operation.
Adult supervision is recommended when operating this car.
• Please ensure all batteries are inserted in the correct direction(see
diagram).
• Ensure all batteries are the correct type and size(see diagram).
• Do not mix old and new batteries.Replace all batteries at the same time.
• Batteries should be installed,changed and removed by an adult.
• Do not mix battery types.Only use alkaline batteries in this product.
• Do not attempt to recharge non-rechargeable batteries.
• Promptly remove depleted batteries from the product.
• Remove batteries from the product before extended storage or product
disposal.
• Do not dispose of batteries in re;batteries may explode or leak.
• To prevent short-circuit of battery terminals,keep battery compartment
free of materials except batteries.
• Do not throw batteries in household trash;dispose of them at battery
collection stations.
FCC NOTICE:
This equipment has been tested and found to comply with the limits for a
Class B digital device,pursuant to Part 15 of the FCC Rules.These limits are
designed to provide reasonable protection against harmful interference in
a residential installation.This equipment generates,uses and can radiate
radio frequency energy and,if not installed and used in accordance with the
instructions,may cause harmful interference to radio communica-
tions.However,there is no guarantee
that interference will not occur in a particular installation.If this equipment
does cause harmful interference to radio or television reception,which can
be determined by turning the equipment o and on,the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules.Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference,and
(2)This device must accept any interference received,including interference
that may cause undesired operation.
LED Indicator.When fully charged, red
LED will be o.
Once the car is fully charged,switch the ON/OFF switch to the ON
position at the bottom of the car. Use a screwdriver to remove the
set-screw of the battery compartment door on the back of the
remote controller.Install 2 AA 1.5V batteries.