Installation Guide
IS-15846-US
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
Fixture Diagram / Diagrama de Accesorios
For warranty informaon please visit: hp://www.kichler.com/warranty
Para informacion de la garana por favor visite: hp://www.kichler.com/warranty
1) Determine desired locaon for mounng xture.
2) At desired locaon, hammer stake[A] into ground. To
avoid damage to stake, place a board on top of stake
while hammering. If ground is hard and stake is dicult
to install, make a crosscut in ground using a at shovel.
3) Clear away area in ground at wireway slot[B] in top of
stake.
4) Lay 12V cable into wireway slot and screw xture[C]
into stake. Aim xture in desired direcon and secure by
ghtening locknut[D]. If necessary, use wrench or pliers
for nal ghtening of nut.
5) Adjust angle of accent light by loosening Phillips head
screw[E].
6) Adjust angle of cowl by loosening thumb screw[F].
7) TURN OFF POWER.
8) Make wire connecons using supplied wire connectors
following instrucons included, or using other approved
wiring connecon method (not supplied).
To set up the output brightness:
• Locate the small indent in the cast aluminum at the top
of the xture. (This is called a magnet locator[G]).
• Place the magnet[H] in the magnet locator.
Assembly and Installaon
Cauons
SAFETY INSTRUCTIONS
READ THIS FIRST
KEEP THESE INSTRUCTIONS
This xture is intended for installaon in accordance
with the Naonal Electric Code (NEC) and Local code
specicaons. Failure to adhere to these codes and
instrucons may result in serious injury and/or property
damage and will void the warranty.
1) WARNING: This xture is not to be installed within 10
feet (3M) of a pool, spa or fountain.
2) This xture is to be used only with a power unit
(transformer) rated a maximum of 300 W (25 AMPS)
15 volts.
3) According to the requirements of the Naonal Electric
Code (NEC), direct burial rated wire is to be buried a
minimum of 6” [152mm] beneath the surface of the
ground.
NOTE: If addional Direct Burial wire is needed, contact
your local Kichler® landscape distributor.
• 8 GA wire can be purchased in length of 250’ (76 M),
15503-BK.
• 10 GA wire can be purchased in length of 250’ (76 M),
15504-BK.
• 12 GA wire can be purchased in lengths of 100’ (30
M), 15501-BK; 250’ (76 M), 15502-BK; 500’ (152M),
15505-BK; and 1000’ (304 M), 15506-BK.
4) Fixture shall not use a tungsten halogen lamp unless the
xture is marked for use with such lamps.
5) Wiring connecons must be made with approved/listed
wire connecon device(s) suitable for the applicaon.
Do not exceed manufacturers’ wiring combinaon
specicaons for size and quanty of conductors.
CAUTION
When installing Kichler Landscape Lighng (line voltage
or low voltage), care should be taken to keep clear of
potenally combusble materials.
When maintaining the xtures, be sure to remove leaves,
pine needles, grass clippings, mulch, or any debris that has
accumulated on the light bulb, lens, or body of the xture.
Parts List
[A] Stake
[B] Wireway Slot
[C] Fixture
[D] Locknut
[E] Phillips Head
Screw
[F] Thumb Screw
[G] Magnet
Locator
[H] Magnet