Operator's Manual

BACtrack Skyn Operator Manual

Intended Use: Collect TAC (Transdermal Alcohol Content) data.

FOR RESEARCH USE ONLY. Not for use in diagnostic procedures.

Assembled in San Francisco

Item# SK-10

FCC ID: S8B-SK-10

IC: 10935A-SK10

Contact: BACtrack, 300 Broadway, Ste. 26, San Francisco, CA 94133

PAGE 1
BACtrack Skyn Operator Manual Intended Use: Collect TAC (Transdermal Alcohol Content) data. FOR RESEARCH USE ONLY. Not for use in diagnostic procedures. Designed by BACtrack in San Francisco Assembled in San Francisco Item# SK-10 FCC ID: S8B-SK-10 IC: 10935A-SK10 Contact: BACtrack, 300 Broadway, Ste.
PAGE 2
Operating the BACtrack Skyn Turn the device over, and press and hold the Power Button (located on the underside next to the charging port). The BACtrack Skyn will immediately power on, and a blue LED light will flash on, then the light will remain on while it connects to an iOS device. The BACtrack Skyn is now ready to be viewed in the app. The device will continue to flash periodically to indicate it is still on. At any time, to confirm the BACtrack Skyn is on, tap the LED light on top. .
PAGE 3
● ● ● The BACtrack Skyn can still be on when no light is flashing, as long as it flashes periodically. To check that the BACtrack Skyn is still on, firmly tap the light square on the top, and the light will flash blue again When the BACtrack Skyn is charging, the LED light will be green and pulsating When the LED is solid green, the BACtrack Skyn is fully charged Charging the BACtrack Skyn Turn off the BACtrack Skyn.
PAGE 4
communications. However, there is no guarantee that interference will not occur in a particular installation.