Specifications

Specifications:
• Power:10W/7.5W/5W
• Input: 5V-2A, 9V-1.67A
• Output: 5V/1A 9V/1.1A
• Coil type: single coil
• Transmission distance: ≤5mm
• Working frequency: 137KHZ
• Conversion efficiency: ≥75%
Includes:
• Wireless Charger
• Micro Cable
(Cord plugs into USB-A outlets.)
Charging Devices:
Plug USB cord into USB port, make sure the micro plug in
the charging pad is connected/secure. Small LED light on
charging pad will light up when plugged into USB port. Place
phone/device on charging pad. Check/Confirm, LED light
will change from Red to Blue when device is charging.
Reposition device if charger not engaging.
Attention:
1. Please keep the charger away from water or other liquid.
2. Please make sure it’s not connected with power supply
when you need to clean the charger.
3. Using environmental temperature remains 0-45°C
Note:
Wireless charger is intelligent item with simple design,
compatible with any mobile phones with Qi standard.
Please note that receiver is required if your phone doesn’t
support.
Made in China
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a
circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. During the
operation of device a distance of 15 cm surrounding the
device and 20 cm above the top surface of the device must
be respected
.