User's Manual

INSTRUCTIONS FOR Radio Control Operator

Single entry transmitter G220

Read the following instructions thoroughly before using the remote.

This transmitter must be adjusted so that the coding switches match the coding on your present operating

transmitters or receiver

FCC Regulations: This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Programming Remote Controller to the Opener

1. Remove the Transmitter Cover

Remove the access cover from the front of the transmitter by sliding the cover

away from the top of the transmitter (Figure A). This will expose the battery

and the dip switches. The code can now be changed using a small screwdriver.

2. Setting the codes

You may set your transmitter to any code you desire, but be sure the code you

set matches both your transmitter and receiver.

There are twelve (12) dip switches, each of which can be placed in two

different positions (+,-). DO NOT set all switches in the same position, such as

all +, all -, (Figure B). WARNING: No other adjustments should be made

inside the transmitter.

3. Terminal block for 9 dip switches receiver

For some receivers which only have 9 dip Switches, it will be necessary for

you to move the small black code terminal (Open the housing with cross-shaped screwdriver (Figure C) to

find terminal block (Figure D) ) to PINS in the middle and 9 .Therefore, the code selection of the 9 dip

switches receiver model and the dip switches on your transmitter 1 thru 9 should be set exactly the same.

The same as those on your receiver, switches 10, 11,12 on the transmitter should be set in the off position.

Open the housing with cross-shaped screwdriver

Figure C

Slider the cover for

battery replacement

Battery Type: 23A

Figure A

Figure B

PAGE 1
INSTRUCTIONS FOR Radio Control Operator Single entry transmitter G220 Read the following instructions thoroughly before using the remote. This transmitter must be adjusted so that the coding switches match the coding on your present operating transmitters or receiver FCC Regulations: This device complies with Part 15 of the FCC Rules.
PAGE 2
For 9 dip switches receiver, you have to move the small black code terminal to PINS in the middle and 9. Figure D Warning To avoid possible serious injury or death from a garage door or moving gate: -Keep all remote controls out of children’s reach at all times. Never allow children near batteries! -Only activate door or gate when it is in clear view and is in proper working condition. -Always completely monitor garage door and gate opener until completely opened or closed.