User's Manual

910805

FCC INFORMATION

The Federal Communication Commission Radio Frequency Interference

Statement includes the following paragraph:

The equipment has been tested and found to comply with the limits for a Class

B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction, may cause

harmful interference to radio communication. However, there is no grantee that

interference will not occur in a particular installation. If this equipment dose cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on , the user is encouraged to try to correct the

interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.

The user should not modify or change this equipment without written approval

Form Keymark Technology Co., Ltd.. Modification could void authority to use this equipment.

Notice : The changes or modifications not expressly approved by the party responsible

for compliance could void the user’s autho rity to operate the equipment.

IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change

to the antenna or the device is permitted. Any change to the antenna or the

device could result in the device exceeding the RF exposure requirements

and void user’s authority to operate the device.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS

SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT

CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY

INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE

UNDESIRED OPERATION.

PAGE 1
FCC INFORMATION The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph: The equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
Use r M a n u a l ( This product will t urn off when com bined; t urn on when separat ed.) 1. When separat ed, t he receiver and t he t ransm it t er proceeds t he linking- code procedure and t hen follows one long & one short beeps, t he LED on bot h receiver side and t ransm it t er side will flash, t hen you can begin t o use t hem . I f t hey cannot flash, it m eans t he linking- code procedure is failed. The receiver sounds cont inuously short ‘‘Beep’’ ( B─ B─ B─ • • • ) per sound.