User guide

96M11577
Copyright (c) 2011 KEYENCE CORPORATION. All rights reserved.
11577E 1021-1 96M11577 Printed in Japan
CA-DZ Series Thru-beam
Diffusion Unit
OP-87328/OP-87329/
OP-87330/OP-87331
Instruction Manual
Read this instruction manual before using the
product in order to achieve maximum
performance.
Keep this instruction manual in a safe place after
reading it so that it can be used at any time.
 Symbols
This manual uses the following symbols so that you
can recognize important messages at a glance.
Please read it in its entirety.
The “OP-87328/OP-87329/OP-87330/OP-87331”
includes the following items. Check if the parts and
equipment listed below are included in the
package of the model you purchased.
F
Thru-beam Diffusion Unit
One unit of the following:
OP-87328 (50 mm use)/
OP-87329 (150 mm use)/
OP-87330 (300 mm use)/
OP-87331 (450 mm use)
F
Installation Screws M3 x L6
(OP-87328/OP-87329) x 4
(OP-87330) x 6
(OP-87331) x 8
F
Instruction Manual (this manual)
Install the thrubeam diffuser unit to the transmitter
of the CA-DZ that has had its diffuser panel
removed using all of the included installation
screws.
Introduction
It indicates a situation which, if
not avoided, could result in
product damage as well as
property damage.
Checking the Package Contents
NOTICE
How to install the CA-DZ Series
The Thru-beam Diffusion Unit is
only suitable for the specified
full length CA-DZ Series.
Do not install to a CA-DZ Series
of a different length or a device
other than the CA-DZ Series.
Appropriate tightening torque
0.5 Nm to 0.8 Nm
NOTICE