User's Manual

1. Introduction on product parts
1). Power on / off
Power on: Press the Power button for seconds and red
light turns on
Power off: Press the Power button for seconds again and
the red light will flash until turn off
2). Wi-Fi on / off
Wi-Fi on: Press the Wi-Fi button, blue light turns on and it
will flash when data transfer.
Wi-Fi off: Press the Wi-Fi button again, blue light will turn off.
3). Recording
Press the Recording button, it will start recording when red light
flash; press the Recording button again, the recording stop. (In
case of no card, full or any error, the red light will flash fast)
4). Recharging
Connecting with USB cable & A/C adaptor, the Red light will
turn on and recharging start; the Red light will turn off when
recharging completed.
5). Reset
Press this button and the camera will reset.
1). Wi-Fi On / Off
2). Power On / Off
3). Recording button
4). TF card port
5). Micro-USB port
6). Reset button
7). Lens
SDV180 Quick Start Guide
6. Camera specification
Lens: F2.0 FOV 190°
Video format: 1920*1080(1080p) 30FPS
Storage: MicroSDHC
Input Current: 1.5A
Input Voltage: 5V
Operating Temperature: - 20°~+70C°
Power: 1.8 Watt
5. Camera Accessory
1. User Manual
FCC Radiation Exposure Statement
Warning
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user ’s authority to operate the
equipment
This device can be recharging via USB cable & A/C adaptor or
power bank and it is recommended to use rating 5V / 1.5A or
above for this operation
2. Recharging
4. Camera App
Smartphone system should be Android 5.0 or iOS 8 & above.
Android users can download the App Ezzy360 from Google play
store and iOS users can download the App Ezzy360 from App Store.
ROHS
This product is in compliance with Directive 2011/65/EU of the European
Parliament and of the Council of 8 June 2011, on the restriction of the use
of certain hazardous substances in electrical equipment.
6
7
5
4
1
2
3
3. Introduction on normal use
5
4
2
1
3
A/C
adaptor
Power
bank
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
o Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
ｅｓｔａｂｌｉｓｈｅｄ ｂｙ ｔｈｅ Ｆ ｅｄｅｒａｌ Ｃｏｍｍｕｎｉｃａｔｉｏｎｓ Ｃｏｍｍｉｓｓｉｏｎ （ＵＳ Ａ）．
Ｔｈｅ Ｓ ＡＲ ｌｉｍｉｔ ｏｆ ＵＳ Ａ （ＦＣＣ ） ｉｓ １．６ Ｗ／ｋｇ ａｖｅｒａｇｅｄ ｏｖｅｒ ｏｎｅ ｇｒａｍ ｏｆ ｔｉｓｓｕｅ． Ｔ ｈｉｓ
ｐｒｏｄｕｃｔ ｈａｓ ａｌｓｏ ｂｅｅｎ ｔｅｓｔｅｄ ａｇａｉｎｓｔ ｔｈｉｓ Ｓ ＡＲ ｌｉｍｉｔｅｄ．
Ｔｈｉｓ ｄｅｖｉｃｅ ｉｓ ａｌｓｏ ｄｅｓｉｇｎｅｄ ｔｏ ｍｅｅｔ ｔｈｅ ｒｅｑｕｉｒｅｍｅｎｔｓ ｆｏｒ ｅｘｐｏｓｕｒｅ ｔｏ ｒａｄｉｏ ｗａｖｅｓ
(The USB port is only for battery charging and
not use for PC connection to transfer data.)