SAFETY PRECAUTIONS A WARNING Observe the following instructions to proven fires and personal injury. & When the Power supply lead or Ground lead are extended, use a 0.78 mm? (AWG 18] or larger automotive grade caliper which will withstand friction and hea: to safe guard against fires occurring as @ result of hart-sircuiting « hake sure that metal phi sots, particularly needles or coins do not get into the unit 1o prevent short circuiting and fires.
TABLE OF CONTENTS # Introduction DIGITAL SIGNAL PROCESSOR e besiege s b 4 SPECIAL FEATURES ...ttt en e v enema Your new Digital signal processor VOLUME CONTROL . HALL SIMULATION . DIGITAL EQUALIZER POSITION CONTROL W DSP memory function KBS (KEN WOOD Built-in Sound} DSP MEMORY M DSP adjustment functions HALL SIMULATION ADJUSTMENT DIGITAL EQUALIZER ADJUSTMENT.. POSITION CONTROL FINE-ADJUSTMENT .18 W Other features SUB-WOOFER SYSTEM OVERBALANCE CONTROL.
DIGITAL SIGNAL PROCESSOR The USP (Digital Signal Processor) simulates the acoustic effects of & concert hall, eto. based on digital control of the components of sound. The components of sound we hear can te divided into the “direct sound” which attains our ears directly from the source such as a musical instrument, and into the "reverberation sound” which attains our ears tater reflections on the walls, selling and finer.
VOLUME CONTROL Turning this knob clockwise, increases the volume, and turning counterclockwise, decreases. = The sot volume is displayed in decibels for B seconds. Volumes o display » To adjust the volume, use the volunteer con taller knob of this unit and do nat use the center unit {cassette receiver, Bic.). increase the volume of the center unit bestow the point of distortion and do not change the volume, Do not control the volume o the center unit, for this may cause noise.
W EQUALIZER CURVES The following preset digit! equalizer curves aro available. Pick the one you prefer, the name are Suggestions only. 1. POPS Adds modulations 10 Instrumental and 2, LOUDNESS Ra produces a crisp sound by vocal music, enhancing the high and low frequencies. Effective when listening 3t a low volume, B o eee] RIFLE’ " .EM BL 3, vocal Emphasizes the human vocal range, intensifies the vocal coloration for greater immediacy. 4.
POSITION CONTROL Crass the Position bitten to change the mode in this order: Front left, Front right, Front, Errs and All. The display changed according (‘ Position display 1o the dissected position. (The position control indicator and the position name display are displayed for B exorcises} Position coral display Poseidon mare dispirit NOTE ® The position contra adjusts the DSF effect, not volumes. ® When the position control is set, the balance control is reset to the center position.
DSP MEMORY Adjust the hall simulation, digital equalizer and position control to make the combination to be stored n memory, ] Press one of memory buttons 1 to 3 and hold it for more than 2 seconds. | =R beep sound is generated when the combination hds been stored under the passed button, By repeating steps 1 and 2, up 10 three combinations of DSP tastings Briefly preach the Memory button. = The stared DSP settings is can be stored under memory recalled.
HALL SIMULATION ADJUSTMENT B Select the hall simulation 1o be | adjusted. = The selected hall simulation name is displayed. REVERBERATION LEVEL # To desecrate the reverberation novel: Tum the Audio controverted I counterclockwise. The level esn be decreased in 25% step down 0 0%, = The adjusted reverberation level is displayed ! Press the Effect button for mots ' than 1 sevens, = The DSP adjustment mode is initiated. TO ADJUST DELAY TIME ® To shorten the delay madman: Pres the < button.
* To inc rouse the reverberation level: Tum the Audio controlled clockwise. Toe label can be increased in 25% spat up 10 100%, = The adjusted reverberation novel is displayed. O RELEASE } . Press and hold the effect bunion for more than 1 second or perform = * Ta lengthen the delay time: Press the > button, The time can be increased in § ms sips up fo 100 ms. = The adjusted delay time is displayed. no operation for § seconds.
DIGITAL EQUALIZER ADJUSTMENT Press the Equalizer bunion for more than 1 second, = The digital equalizer divestment mode is initiated, 3 TO DECREASE LEVEL Turn the Audio control counterclockwise wheels the band to bg adjusted is shown in inverted display. The level of the band oan be decreased down The level indicator moves downward. Select the frequency band to be adjusted with the < and > buttons.
Terr the Audio control clockwise while the band o be adjusted s shown in inverted display. The level of the band can be increased The label indicator moves upward. Stadium all frequency bands by repeating steps 2 and 3 for each of Press and half the Equalizer button for mere than 1 second or perform no operation for & seconds. = The digital equalizer adjustment mode is terminated.
POSITION CONTROL FINE-ADJUSTMENT Select a position as described on Turn the Audio control sa that you page 10, can feel the hall simulation effect best, I I Turning the control clockwise fine adjusts the listening position in order of: front = fight = RAF = left =2 center. Turning the control counterclockwise reverses thi order. o = The fine-adjustment direction s i displayed according to the | Audio control position. Press the Position button for more than 1 second.
decrease output level: Turn the Audio controlled counterclockwise. The label can be decreased in 2 dB step down The adjusted output revel s displaced. « To increase output level: Tums the Audio controlled classicists. The level can be increased in 2 dB step The adjusted output level is displayed.
OVERBALANCE CONTROL Briefly pass the Audio bunion will enable the Overbalance control, becomes possible to adjust in the order of Balance end Wader and back to Va lure i briefly press Very time, Ur less it is pressed, Volume and it Adjustment will be made by the Audi controller respectively, For operations and display, refer to he following table, 7 AN preys i the Audio button Is pressed for more than 1 second or i no aeration is performed within 5 seconds, the unit returns 1o the i volume adjustment mode.
1+ ity DELECTABLE ILLUMINATION Every time the Illumination butter iz pressed for more than 1 second, it will switch over between the colors af green and range.
PROCEDURE @) Before instillation and wiring, remove the (3 terminal of the battery o preterit short. circuiting. @ Conn pot the Input and cutout cords of the stern. Connect the Ground lead {Black) 1o the metal chassis of the car, Conn act the Power supply deaf (Yellow). Stall the unit in the car.
SPECIFICATIONS 00— DSP Section AID sorter DIA converter Equalizer center Equalizer range.. Frequency response . Total harmonic distortion signal-o-npise ratio . Dynamic range .. 84 times over sampling, &5 intimidation 1 Bit, 192 time aver sampling HE adulation 00 Hz, 2B0 Hz, 588 He, 1,26 kHz, B kHz; 16 kHz . 20 Hz~20 kHz (%1 dB) 0.005% {1 kHz) 100 a8 gads Audio Section Input impedance Prevent level General Operating hags L1448V (1116 ) Current consumption MAX} 08 A Ingratiation size {WxHx D).