User's Manual

TRMS-ANT-10000
INSTALLTION MANUAL
AND USE’S GUIDE
Component:
1: Main unit 2:Cable
3: Adapter 4: software disk
Host Installtion:
Install the ANT-1000 RTMS to the higher roof and make it fixed, then install the standard antenna to the host and
plug in the 5 Pin cable plug, and connect the 5 Pin cable plug’s other end to the 232 serial port of PC. Supply the power for
the host by the standard power.
About the PC software, specifically see the TRMS YARD MANAGEMENT SYSTEM OPEAREATION MANUAL.
This device complies with Part of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference
(2) this device must accept any interference received, including interference that may cause undesired operation
Caution content:
changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the
receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced
radio/TV technician for help.