Use & Care Guide ® Liquid Sears Propane Model Gas Grill No: 119.16433010 Safety Parts Use and Care Assembly Espa_ol, This Grill Pg. 30 is for Outdoor Use Only Grill Information Missing Parts? Operation • Read and and Use Guide this to this fire Assembly, Instructions in this all & Care or explosion, in property injury or death.
Primary Safety Warranty Warnings. .................................. Information Pre-Assembly ............................................ instructions Part Diagram .................................... and Lists ...................................... Assembly Instructions ..................................... Use & Care Instructions ................................. IF YOU SMELL 1-3 2 Shut 3 Extinguish Open 4-7 appliance. any open flame. lid.
DO NOT the light Lighting DO NOT burner grill without first The reading this tubes for grill without blockage during checking that shipment. Maintenance installation in the Instructions. light occurred and this could See the National Cleaning Fuel Instructions. • DO NOT DO NOT burner • use any type operate the at the ALWAYS use. same inspect Remove main time. the and of charcoal burners (If grease clean in this and grill.
F A Phillips Qty: Head Bolt M6×35mm 4 pcs Qty: lm Phillips Qty: Phillips Head Screwdriver 1 pc G B Head Bolt M6x16mm 24 pcs Battery Qty: Size AA 1 pc H C Phillips Qty: Head Bolt M6xl0mm 4 pcs Cabinet Qty: Door 1 pc D Phillips Qty: Head Bolt M4×Smm 22 pcs "S" Qty: Hook 3 pcs E Plastic Qty: Washer 8 pcs M6 Washer Qty: M4 4 pcs Stop
Key Qty Part No.
Part Description Key Qty C2 1 $7004-042D-001 No.
_----(
Remove [] [] [] Cabinet Cabinet from Cabinet Cut fastening straps on Cabinet Toe Plate. Remove the Toe Plate and set aside. Cut fastening straps securing regulator and hose to cabinet. Unscrew and discard the 8 Phillips Head Bolts (M6x35mm) and 8 Washers (M6) from the corner holes of the cabinet. Remove the crossbar and set aside. With the aid of an assistant, carefully lift the cabinet up from the firebox and set aside. Remove all foam packing from the Firebox.
Install [] [] Cabinet Toe Plate Attach the Cabinet Toe Plate to the Cabinet Bottom (M6xl0mm), Place cabinet in upright position on casters, Panel using 4 Phillips Head Bolts Phillips Head Bolt M6xl0mm Qty: 4 Install Cabinet Doors and Cabinet Front Crossbar [] Insert the Cabinet Right Door bottom pin into the Cabinet Bottom Panel (Inset 1), and insert the Cabinet Right Door top pin into the Cabinet Front Crossbar (Inset 2), With door magnets extending into Cabinet, attach the Cabinet Front Cros
Hang Condiment Basket and attach Cabinet Door Stop [] Attach the Cabinet Door Stop to the front of cabinet bottom using (M4x8mm), [] Hang Condiment Basket on the inside of Cabinet Right Door, 2 Phillips Head Bolts Phillips Head Bolt M4x8mm Qty: 2 Cabinet Door Stop Qty: 1 /.
Install [] Grease Tray Insert the Grease Tray along two sides of the Firebox from the back underneath the firebox. Insert tray with the grease drain hole positioned as shown. Be careful when sliding the tray wires and fuel line. Slide tray fully in until it locks into place behind stops. .............
Install Side Shelf Upper and Lower Front Panels [] Attach the Side Shelf Upper Front Panel to Side Shelf Frame using 3 Phillips Head Bolts (M4xSmm), [] Attach the Side Shelf Lower Front Panel to Side Shelf Upper Front Panel using 3 Phillips Head Bolts (M4x8mm), Phillips Head Bolt M4x8mm qty: 6 I_l Install Towel Bar Handle, "S" Hooks [] Slide 3 "S" Hooks onto the Towel Bar Handle, Use 2 Phillips Head Bolts (M4x8mm) and 2 Washers (M4) to attach the Towel Bar Handle to the Side Shelf Frame, Note: When shelf
Znstall Side Burner Upper and Lower Control Panels [] Attach the Side Burner Upper Control Panel to Side Burner Frame using 3 Phillips Head Bolts (M4xSmm), [] Attach the Side Burner Lower Control Panel to Side Burner Frame using 3 Phillips Head Bolts (M4xSmm), Phillips Head Bolt M4x8mm qty: 6 Znstall [] Towel Bar Handle Use 2 Phillips Head Bolts (M4x8mm) and 2 Washers Bar Handle to the Side Burner Frame, Phillips Head Bolt M4x8mm qty: 2 Washer Qty: IV]4 2 13 (M4) to attach the second Towel
Install [] [] [] Side Shelf Frame to Firebox Unscrew the 2 Phillips Head bolts ¼ inch from the upper left and right corner holes in the right side of the firebox as shown in Inset 1. The bolts extending out of the firebox sides are to attach the side shelf frame. Slide the upper holes of the side shelf frame over the heads of the 2 Phillips Head Bolts and drop down. Use 2 Phillips Head Bolts (M6x16mm) to attach the lower holes in the side shelf frame to the firebox as shown in Inset 2.
Install Side Burner [] Unscrew the 2 [] [] [] Frame Head to Firebox Phillips bolts 1/4 inch from the upper left and right corner holes in the left side of the firebox as shown in Inset 1. The bolts extending out of the firebox sides are to attach the side Burner frame. Slide the upper holes of the side Burner frame over the heads of the 2 Phillips Head Bolts and drop down. Use 2 Phillips Head Bolts (M6x16mm) to attach the lower holes in the side Burner frame to the firebox as shown in Inset 2.
Install [] [] [] [] [] Side Burner Valve Detach side burner ignition wire from the regulator hose. Feed side burner valve and igniter wire through hole in left side of cabinet. Open side burner lid and cut tie wrap securing grate to pan. On underside of pan, remove the 2 screws holding the side burner in place. See Inset 1. Secure the side burner valve stem to the Side Burner Lower Control Panel using 2 Phillips Head Bolts (M4x8mm). See Inset 2. Center the side burner valve into the side burner tube.
Install Heat Diffusers, Cooking Grates, Warming Rack [] Insert the heat diffusers into the firebox by placing them back of the firebox. See Inset 1. [] Place the Cooking See Inset 2. [] Insert the warming back of the firebox. Grates into the firebox. The grate rack into the top of the firebox. See Inset 3. into the indentations bottoms have a small See Inset 3. The raised in the front and knob on each corner.
Install [] Battery Qty: 1 Battery Unscrew the electronic ignition button. Place the AA Battery into the ignition end facing out. Screw the electronic ignition button back into place. with the positive (+) Size AA - Assemblylabels is or now complete! []Congratulations Remove any additional packing material from the grill except the CSA label. Be sure to clean all foam packing material out of all areas. [] Read the remaining sections of the Use 8( Care Guide prior to operating your grill.
CORRECT LP GAS TANK USE • Never allow children to operate your grill. Do not allow children or pets to play near your grill. • Use of alcohol or drugs may impair the ability to assemble and operate the appliance. • Keep a fire extinguisher readily accessible. In the event of an oil or grease fire, do not attempt to extinguish with water. Use a Type B extinguisher or smother with dirt, sand, or baking soda. • In the event of rain, cover the grill and turn off the burner and gas supply.
Notes about LP Gas Tank Exchange Programs Regulator Many retailers that sell grills offer you the option of replacing your empty LP gas tank through an exchange service. Use only those reputable exchange companies that inspect, precision fill, test and certify their tanks. Exchange your tank only for an OPD safety feature equipped tank as described in the LP gas tank section of this manual.
Flow Limiting Your LP gas valve that sudden tank will should the with flow knowledge. your grill will take longer light all burners. you is equipped in pressure. your that on LP Gas Tanks restrict change without things Valves to reset You heat If you the and burner to first among other line. valve is OFF. from knobs same the LP gas tank. including the time. 7. Slowly, turn 8. 9.
Grill Lighting 1. Instructions Before each nicks, cuts, damaged check authorized part make all sure do the hose with from the Parts Do not Care Open use with while gas supply the the the List. to replace supply connections, serious 5. lighting grill are and manual. the grill or Main Burner connections. has gas. lid. Side a faulty in a fire injury, control tank Burner the that knobs could cause or property to OFF 2.
MANUALLY LIGHTING THE HOLDER MATCH THE BURNERS WITH MANUALLY OR 1. Open the lid 2. Ensure 3. Slowly turn on the gas at the LP cylinder valve if it is not already on. all burners are in the "OFF" position. THE LIGHTING Place a match This is located 5, Use the stick to slide the lit match through the cooking grates and the front of the heat diffuser to the burner you wish to light. Press and turn 6, in the manual igniter stick. inside the left cabinet door.
Troubleshooting If the grill fails to light: 1. Turn gas off at source and turn control knobs to "OFF". Wait at least 5 minutes for gas to clear, and then retry 2. If your grill still fails to light, check the gas supply and connections. Ensure gas supply is turned on (turn counterclockwise), there is gas in the tank, and the regulator is properly seated in the tank valve. 3. 4. [] [] Follow the steps limiting device, Repeat lighting procedure.
9. Proper care and maintenance good operating condition and these grill cleaning will CAUTION: cleaning, cleaning procedures stay clean Be sure and your always and your wear grill with basis minimum is off and protective cool gloves and over each valve Check the and clean each spacing will keep your grill in prolong its life. Follow on a timely operate down tip your the space between should be approximately 11. rack, and Reconnect burner grill.
Regardless of the burner cleaning procedure you use, we recommend you also complete the following steps to help prolong burner life. 1. Use a fiber pad or nylon brush to clean the entire outer surface of each burner until free of food residue and dirt. 2. Clean any clogged ports with a stiff wire, such as an open paper clip. 3. Inspect each burner for damage (cracks or holes) and if such damage is found, order and install a new burner.
Burn-Off Do not place the food directly over a burner to use this method. Instead, the food should be placed on the left or right side of your grill with the burner lit on the opposite side or in the center with the center burners off. Indirect Some of the new parts of your grill could have residual oils. We recommend you ignite the burners, turn to "Hi", and lower the lid for 3 to 5 minutes to burn any oils off before grilling for the first time.
Question: Can I convert my gas grill from one fuel type to another, such as LP to NG (natural gas) or vice versa? the electronic Be sure the 3. electronic ignition control Inspect 4. Answer: No, your gas grill is manufactured to specific standards developed by CSA and ANSI for your safety and is certified for one type of gas only.
Question: Where do I use operation and my grill better for Question: safer Can performance? Answer: Strong winds and low temperatures the heating and performance so factor in these elements your grill outdoors Use your grill (such overhangs) lights 3 feet that or wood away can No.
Congratulations onmakinga smartpurchase.Your newKenmore
Your Home For exped troubleshooting ++++++++++++++++++++ and home solutions advice: a n a9 ÷ www,managemyhome,com For repair- in your home- of al! major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For,the replacement pads, accessories and owner s manuals that you need to do-it-yourself. For Sears professional installation of home appliances and items like garage door openers and water heaters.