Chapter 4: Mechanical installation 4.3 LPA-A3 Antenna 4.3.1 Lifting The health and Safety notices shown at the beginning of this handbook must be observed at all times when installing, terminating, commissioning, operating and maintaining the equipment and its subassemblies.
Chapter 4: Mechanical installation 4.3.2 Tools, torque settings & bolts TOOLS MOUNTING BOLTS TORQUE VALUES BOLT DESCRIPTION TORQUE MAIN MOUNTING BOLTS 56Nm SWING CASTING BOLTS 7Nm WAVEGUIDE COUPLING 4.3.3 2.
Chapter 4: Mechanical installation ANTENNA INSTALLATION PROCESS NOTICE FIT TWO OF THE MOUNTING BOLTS CAUTION: ANTENNA SUPPORT FIT THE RF COUPLING (BULLET) CONNECT THE FLEXWELL 2.26Nm FIT THE REMAINING MOUNTING BOLTS 56Nm 7Nm WATERPROOFING ANTENNA CLEARANCE 4.3.4 Dimensions Please refer to section 4.2.7 for the antenna dimensions.
Chapter 4: Mechanical installation 4.
Chapter 4: Mechanical installation CLEARANCE NOTE Page 29 of 80
Chapter 4: Mechanical installation 4.
Chapter 4: Mechanical installation Page 31 of 80
Chapter 4: Mechanical installation Page 32 of 80
Chapter 5: Termination 5 Termination 5.1 Pre-termination requirements The health and Safety notices shown at the beginning of this handbook must be observed at all times when installing, terminating, commissioning, operating and maintaining the equipment and its subassemblies.
Chapter 5: Termination 5.2 Internal layouts 5.2.
Chapter 5: Termination 5.2.
Chapter 5: Termination 5.3 Cable & connector information 5.3.1 Cabling requirements CABLING STANDARDS MARKING & IDENTIFICATION CABLE LAYING AND SECURING CABLE PULLING THE PROTECTIVE SLEEVE MUST NOT BE REMOVED UNTIL THE CABLE HAS BEEN PULLED AND THE SYSTEM IS READY TO BE TERMINATED.
Chapter 5: Termination 5.3.
Chapter 5: Termination 5.3.
Chapter 5: Termination DETAIL OF FIBRE OPTIC CABLE & PROTECTIVE SLEEVE M25 threaded gland body Aramid fibre strain relief Fibre optic cable Gland seal compression nut Polyurethane sheathed aramid fibre reinforced fibre optic cable Protective pulling tube M20 threaded plastic pulling tube adaptor Metal M20/ M25 thread adaptor The M20 black plastic section and the metal M20/ M25 threaded adaptor of the pulling tube MUST BE REMOVED from the cable assembly before fitting the metal cable gland into the M
Chapter 5: Termination 5.3.
Chapter 5: Termination 5.3.5 LAN Cable and connectors CABLE PART No. 45-762-0279-001 CAUTION: DO NOT USE UNSHIELDED CABLES or RJ45 CONNECTORS BEND RADIUS CONFIGURATION RJ45 CONNECTOR PART No.
Chapter 5: Termination 5.3.6 Grounding CONNECTION POINT CONDUCTIVITY TESTS WRIST STRAPS CABLE SCREENS 5.3.
Chapter 5: Termination 5.3.
Chapter 5: Termination 5.3.