Chapter 6: Commissioning 6 Commissioning 6.1 Transceiver The health and Safety notices shown at the beginning of this handbook must be observed at all times when installing, terminating, commissioning, operating and maintaining the equipment and its subassemblies. HANDBOOK REFERENCE HBK-2300-2 COMMISSIONING AUTHORISATION CAUTION 6.
Chapter 6: Commissioning 6.3 Antenna speed DEFAULT SETTING CAUTION: 40RPM/ HIGH SPEED SETTING Example of GTX-A104 set for 24rpm LOW SPEED: 24 RPM DEFAULT SETTING HIGH SPEED: 40 RPM DO NOT USE; SEE CAUTION above 6.4 Inverter status 25.0Hz DEFAULT SETTING or 50.
Chapter 7: Completion of installation 7 Completion of installation CLEAR THE WORKING AREA DISPOSAL OF PACKAGING FUNCTIONAL TESTS KEYS WARRANTY CARDS Page 49 of 80
Chapter 7: Completion of installation Page 50 of 80
Chapter 8: Operation 8 Operation 8.1 DTX-A1-xxxx The health and Safety notices shown at the beginning of this handbook must be observed at all times when installing, terminating, commissioning, operating and maintaining the equipment and its subassemblies.
Chapter 8: Operation 8.
Chapter 8: Operation 8.3 Switch ON/ OFF SWITCH ON PROCEDURE MAINS ON ON/ OFF Note MOTOR ON SWITCH OFF PROCEDURE ON/ OFF Motor ON MAINS ON WARNING: AC OFF BUT NOT ISOLATED OFF command WARNING: SYSTEM ISOLATION 8.
Chapter 8: Operation 8.5 SYSTEM ISOLATION DISPLAY SUB-SYSTEM THREE-PHASE AC ISOLATION ON/ OFF OFF SINGLE PHASE ISOLATION MAINS ON MOTOR ON WHEN CONFIGURED AS DETAILED ABOVE, THE SYSTEM IS ISOLATED.
Chapter 9: Planned maintenance 9 Planned maintenance 9.1 Overview The health and Safety notices shown at the beginning of this handbook must be observed at all times when installing, terminating, commissioning, operating and maintaining the equipment and its subassemblies.
Chapter 9: Planned maintenance 9.
Chapter 9: Planned maintenance 9.3 Annual maintenance EQUIPMENT DETAILS Gearbox Part number: Low Profile Antenna Part number: Serial number: Serial number: MOD strike: MOD strike: Drive Control Unit Part number: Serial number: MOD strike: Inspection date: Inspected by: Print: Sign: for opening Drive Control Unit Tools required: Note: Do not use abrasive cleaners or products containing alcohol.
Chapter 9: Planned maintenance LPA-A3 ANTENNA INSPECTION TASK CLEANING DESCRIPTION PASS FAIL PASS FAIL NOTES PHYSICAL INSPECTION CAUTION all TASK safely DESCRIPTION Antenna not accessible Page 58 of 80
Chapter 9: Planned maintenance DTX-A1-XXXX GEARBOX INSPECTION TASK DESCRIPTION PASS GENERAL CLEANING DESICCANT REPLACEMENT any SEVERE WEATHER CHECKS PHYSICAL INSPECTION EARTH BONDING AND CONTINUITY Page 59 of 80 FAIL
Chapter 9: Planned maintenance GTX-A24 DRIVE CONTROL UNIT TASK DESCRIPTION PASS EXTERNAL SURFACES CLEANING INTERNAL SURFACES EXTERNAL PHYSICAL INSPECTION INTERNAL GENERAL EARTH BONDING AND CONTINUITY Note: Page 60 of 80 FAIL
Chapter 9: Planned maintenance RESTORE POWER TO THE SYSTEM TASK DESCRIPTION COMPLETED AC SUPPLY SECURITY SWITCHES TEST SAFETY SWITCH TESTS WARNING: HEALTH & SAFETY GTX-A24 KEYSWITCH OPERATION TASK DESCRIPTION PASS The antenna should be rotating. MOTOR ON/ OFF KEYSWITCH OPERATION Antenna Rotation should have stopped Antenna rotation should have resumed.
Chapter 9: Planned maintenance 9.
Chapter 9: Planned maintenance 9.