Operating Manual of Remote Control system 1、 Interface of the remote control 2、Button description A. HEAD UP button：Press and hold the button, the Head actuator will go up. Stop when released. B. HEAD DN button：Press and hold the button, the Head actuator will go down. Stop when released. C. FOOT UP button：Press and hold the button, the Foot actuator will go up. Stop when released.
D. FOOT DN button：Press and hold the button, the Foot actuator will go down. Stop when released. E. ZERO GRAVITY button: Click the button, the Head and Foot actuator will start up and keep running until arriving to the zero gravity position. Running can be stopped by clicking any button. F. FLAT button: Click the button, the Head and Foot actuator will start up and keep running until arriving to the FLAT position. Running can be stopped by clicking any button. G.
Step 1: Click the button to flat the bed; Step 2: Adjust the Head and Foot position to a desired position by pressing the button HEAD_ UP or HEAD_DOWN or FOOT_UP or FOOT_DOWN; Step 3: Press and hold the Step 4: Release the button for 3sec, backlight LED start flashing; button then click one of or or button before LED stop flashing. Then the Flashing stops immediately to indicate the corresponding operating has completed successfully.
K. Foot Massage INTENSITY ICREASEMENT and DECREASEMENT button： Click the button the Foot vibrating intensity will raise up one level, total 4 levels. The number of level represents the vibrating intensity. More big number of the level, more strongly vibrating it is. The strongest vibrating is level 3, and the weakest is level 0. Implement adjustment of the vibrating intensity is the way known as “PWM”. Different duty cycle of PWM makes different intensity.
Step3: Hold the silicone button in the batter cover on the back of the remote control device, when the LED in the silicone button flashes, it indicates that the remote control is searching for the repaired control box. When the LED of matching button within the remote control has a long light and the LED on the paired control box is off at the same time, the pairing operation is finished.
5、Connect to the Control Box The control box is designed for using the SMPS of 29VDC/ around 2A as the power. It is necessary to use the SMPS provided by us when normal operation. In the case of the AC power utility failure, the batteries for backup of 18VDC can be used as the power. It is only for flatting the bed plate without load if the batteries used as the power and each one of the batteries must be new with 9V voltage.
4340 JLDP.15.001.007 Actuator Foot B11687 3.00.209.033.00 B11709 3.00.401.151.
FCC NOTE： Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
