Item Brochure

HSGM HEAT KNIFE &
HEAT KNIFE CARRIER
Toll Free: 800-523-4855
Phone: [phone]
Fax: [phone]
204B Progress Drive,
Montgomeryville, PA 18936
www.go-foster.com
5-year general warranty on Carrier.
20-year warranty on Carrier’s bearings.
1-year limited warranty for manufacturer defects on HSGM heat knives.
Item # Description
60398 ................................................ Heat Knife Carrier for HSGM Heat Knife
67100 .................................................HSGM Heat Knife (blade not included)
67101 .......................................................... HSO-N Blade- Fine tip blade
67102 .......................................................... Type R blade- Broad tip blade
Designed specically for fabric graphics cutting and nishing, Foster Keencut’s Heat Knife Carrier ts on the Sabre, Sabre 2, Evolution
and Evolution-E2 cutter bars. e carrier device accepts HSGM’s HSG-0 heat knives and blades.
What you can expect:
Accuracy.
Human errors and makeshi straight edges are now a thing of the past. With a single Allen key adjustment, the Heat Knife Carrier
attaches directly to your Foster Keencut cutter bar. e Heat Knife cuts approximately ¼ inch from the cutter’s aluminum extrusion
bar, ensuring precision straight-line fabric cuts in the same location every time.
Speed.
Your shop can accommodate today’s high-demand fabric graphics – and more of them – using the heated blades of HSGM knives
that cut and seal the edges of synthetic fabrics.
Eliminate the time associated with cumbersome
hand-cutting and nal trimming of frayed or
unraveled edges.
Safety.
e Heat Knife Carrier is safe to use. When the
spring-loaded Heat Knife is depressed, a center
post triggers the heating mechanism. As soon as it
is released, the heating element automatically turns
o.
HSGM Heat Knife Use & Specications
• Blade heat time: 6-8 seconds
• Blade temperature: approx. 1100 degrees
Fahrenheit (600° C.).
• Electrical: Uses 120 V, 60 W
e HSGM Heat Knife and Carrier does not interfere with
the Evolution or Sabre’s cutting head.
Pictured on the Evolution-E2 cutter bar.