Instructions / Assembly

ManualsBrandsKAWOTI ManualsLighting4-light Black Metal Sphere Chandelier Foyer Pendant Light

Mounting strip

1 pc

Outlet box screw

2 pcs

Threaded tube

1 pc

Hex nut

1 pc

Lock washer

1 pc

Green ground screw

(Pre-assembled to mounting strip)

1 pc

Wire connector

3 pcs

Screw collar loop

1 pc

Ring

(Pre-assembled to

screw collar loop)

1 pc

H10

Quick link

2 pcs

H11

Canopy

1 pc

H12

Chain

1 pc

USE AND CARE MANUAL

4 LIGHT CHANDELIER

Model number: 21206/21213

THIS MANUAL CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND

KEEP FOR FUTURE REFERENCE.

Page 1 of 5

Hardware

(Parts are not to scale)

Summary of content (5 pages)

PAGE 1
USE AND CARE MANUAL 4 LIGHT CHANDELIER Model number: 21206/21213 A B H1 Mounting strip 1 pc H5 Lock washer 1 pc H9 Ring (Pre-assembled to screw collar loop) Hardware (Parts are not to scale) H2 H3 H4 H6 H7 (Pre-assembled to mounting strip) Wire connector 3 pcs H8 H10 H11 H12 Outlet box screw 2 pcs Green ground screw 1 pc Quick link 2 pcs Threaded tube 1 pc Canopy 1 pc Hex nut 1 pc Screw collar loop 1 pc Chain 1 pc 1 pc THIS MANUAL CONTAINS IMPORTANT SAFETY INFORMATION.
PAGE 2
IMPORTANT SAFETY INFORMATION • Please read and understand this entire manual before attempting to assemble, operate or install the product. • Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). • Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
INSTALLATION (continued) Attaching the canopy to the 3 outlet box Assembling the loop and the socket 4 assembly to the largest shade • Place the canopy (H11) over the threaded tube (H3), and screw the screw collar loop (H8) onto the threaded tube (H3). • Secure the canopy (H11) using the ring (H9). • Guide the fixture wire with bare copper ground wire through the loop (A) as shown. • Screw the loop (A) onto the fixture body (B).
PAGE 4
INSTALLATION (continued) Making the electrical 7 connections • Strip 3/4 in. of insulation from the wire ends. • Connect the glossy live wire from the fixture to the black wire from the outlet box, and the rough neutral wire from the fixture to the white wire from the outlet box. H7 • The bare copper ground wire from the fixture must loop one turn under the head of the green ground screw (H6) on the mounting strip (H1) before it is connected to the ground conductor of the supply circuit.
PAGE 5
CLEANING • Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or wipe carefully. • To clean the fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. Use a dry or slightly dampened, clean cloth to wipe the exterior surface of the fixture. TROUBLESHOOTING • The light does not come on at all: a) Check whether the bulbs were burned out. b) Make sure the wall switch is on.