Instructions / Assembly

ManualsBrandsKawoti ManualsLighting22 in. 3-Light Matte Black Vanity Light with Rippled Glass Shade

USE AND CARE MANUAL

3 LIGHT VANITY

THIS MANUAL CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND

KEEP FOR FUTURE REFERENCE.

Page 1 of 4

Hardware

(Parts are not to scale)

Mounting bracket

(Pre-assembled to

fixture body)

1 pc

Support screw (long)

(Pre-assembled to

mounting bracket)

2 pcs

Hex nut

(Pre-assembled to

mounting bracket)

2 pcs

Outlet box screw (short)

2 pcs

Green ground screw

(Pre-assembled to

mounting bracket)

1 pc

Wire connector

3 pcs

Cap nut

(Pre-assembled to

mounting bracket)

2 pcs

Thumbscrew

9 pcs

Summary of content (4 pages)

PAGE 1
USE AND CARE MANUAL 3 LIGHT VANITY A B C H1 Mounting bracket (Pre-assembled to fixture body) 1 pc H4 Outlet box screw (short) 2 pcs H7 Cap nut (Pre-assembled to mounting bracket) Hardware (Parts are not to scale) H2 Support screw (long) (Pre-assembled to mounting bracket) 2 pcs H5 Green ground screw (Pre-assembled to mounting bracket) H3 Hex nut (Pre-assembled to mounting bracket) 2 pcs H6 Wire connector 3 pcs 1 pc H8 Thumbscrew 9 pcs 2 pcs THIS MANUAL CONTAINS IMPORTANT SAFETY INFORMATION.
PAGE 2
IMPORTANT SAFETY INFORMATION • Please read and understand this entire manual before attempting to assemble, operate or install the product. • Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). • Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
INSTALLATION (continued) 3 Making the electrical connections H6 • Strip 3/4 in. of insulation from the wire ends. • Connect the black wire from the fixture to the black wire from the outlet box, then connect the white wire from the fixture to the white wire from the outlet box. • The bare copper ground wire from the fixture must loop one turn under the head of the green ground screw (H5) on the mounting bracket (H1) before it is connected to the ground conductor of the supply circuit.
PAGE 4
INSTALLATION (continued) Assembling the finials and glass 6 Installing the light bulbs 5 shades • Tighten the two finials (A) to fixture body (B). • Place the glass shade (C) over the socket, align the three holes of the glass shade (C) and cap of the socket on the fixture body (B), then secure the glass shade with the thumbscrews (H8) as shown on the diagram. • Install the light bulbs (not provided) into each socket. Use three MAX 60 W medium base (E26) type "ST64" bulbs (recommended).