W-03 THE CONFERENCE UHF
1.FOREWORD.................................................................................2 2.INTRODUCTION...........................................................................2 3.SYSTEM FEATURES.....................................................................2 4.SYSTEM TYPE..............................................................................2 5.EIGHT CHANNEL RECEIVER FEATURES.........................................3 6.TRANSMITTER FUNCTION & FEATURES......................................
EIGHT CHANNEL RECEIVER FEATURES 1. Grille: Protects the cartridge and help reducing the breath sounds and wind 1 noise. 2 8 3 4 5 2. LCD Information Display: Show the transmitter frequency channel ect. 3.Down Function Button: Sets channel data. 6 7 6 7 6 7 6 7 4.Up Function Button: Sets channel data. CH5 CH6 CH7 CH8 CH1 CH2 CH3 CH4 5 2 3 4 5 5.Power and Audio Mute Switch. 6 UHF PLL 6.Battery Cover: Open it to install the battery.
TRANSMITTER BATTERY INSTALLATION BODYPACK TRANSMITTER CONNECTION 1. Battery Installation of Handheld Microphone: Open the battery cover, Insert the supplied batteries into battery jar in polarity and cover the battery 1. Lavalier Microphone Connection: Connect the connecter of supplied lavalier microphone to the connecting jack of transmitter (shown as below) Set the transmitter work state in wireless lavalier system(L). 2.
OPERATING INSTRUCTIONS 1. Receiver Operation Power on receiver, press two "UP" buttons of module 2 and 3 together for 1 second to enter the adjustment, when the LCD displays "UnLOC", it is under "Normal Operation". When the LCD displays "LOC", it is under "Locking Operation". a.
13-15 1000mA 394MM X 205MM X 52MM X2 7 238MM X 50MM X 50MM 250MM X 51MM X 51MM X2 7 460 970 100MM X 65MM X 30MM 164 50 CONFERENCE MICROPHONE SPECIFICATIONS 8 X2 7 174MM X113MM X 48.5MM(Φ19.
FCC warning statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1)this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. The device has been evaluated to meet general RF exposure requirement.