User Instructions

Table Of Contents
Kapsch TrafficCom
TDMA Transponder Mounting Instructions
For Commercial Vehicles
The TDMA V6 transponder mounts in truck interiors on the windshield. LEDs on the side of the transponder
provide transaction feedback. Mount the transponder with the LEDs visible to the driver.
Requirements
> The TDMA V6 transponder cannot be used on trucks that are equipped with metallic sun visors as these visors block the RF
signal to and from the transponder. If the vehicle is equipped with metallic sun visors, use an externally mounted transponder.
> For reliable operation of the transponder, the vehicle should not be equipped with more than one transponder of similar design
while passing through a toll facility. Other transponders present in or on the vehicle must be switched off or enclosed in an RF
shield.
> The mounting location must provide direct line-of-sight communication between the transponder and the toll facility overhead
antenna.
> Apply Dual Lock™ fasteners in accordance with 3M™ document 700709-4029-4.
> The transponder must not be obscured by a windshield wiper when the windshield wiper is in its parked position (turned off).
Transponder Obscured by Wiper
Wiper
Transponder
EN

Summary of content (2 pages)