User's Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsJANUSÂ® HOTPassÂ® Interior OBU

Janus

HOTPass

Interior Transponder

Mounting Instructions

The HOTPass

interior transponder mounts on the vehicle windshield. The preferred mounting location

is between the roofline and the rear view mirror post. If there is not enough room in the preferred

mounting location to accommodate the HOTPass

transponder, the transponder can be mounted beside

the rear view mirror post. The HOTPass

transponder is secured using 3M

™

Dual Lock

™

fasteners.

HOTPass® Interior Transponder Mounting

Instructions

1. Select a mounting location on the front windshield. The HOTPass

transponder should be mounted � in., but no more that 2 in. from the

roofline. The preferred mounting location is between the roofline and the

rear view mirror mounting post, with a minimum of � in. between the

transponder and the rear view mirror post.

Requirements

For reliable operation of the transponder, the vehicle must be

equipped with only one transponder while passing through a toll

facility. Other transponders present in or on the vehicle must be

switched off or enclosed in an RF shield.

The mounting location must provide direct line-of-sight

communication between the transponder and the toll facility

overhead antenna.

Do not mount the HOTPass

transponder on vehicles:

with non-metallic roofs.

with windshields covered in RF-blocking material (ex. metal oxide).

with a metallic center windshield dividing post.

without center-mounted rear view mirrors.

Handheld mobile communication devices must not be located within

12 in. of the transponder.

Metal objects (except for the rear view mirror and the roof) must not

be located within 6 in. of the transponder.

HOTPass

transponders cannot be used where local regulations prohibit

mounting transponders on the windshield.

Apply Dual Lock

™

fasteners in accordance with 3M

™

document.

70-0709-4029-4.

Kapsch TrafficCom IVHS

Summary of content (2 pages)

PAGE 1
Kapsch TrafficCom IVHS Janus® HOTPass® Interior Transponder Mounting Instructions The HOTPass® interior transponder mounts on the vehicle windshield. The preferred mounting location is between the roofline and the rear view mirror post. If there is not enough room in the preferred mounting location to accommodate the HOTPass® transponder, the transponder can be mounted beside the rear view mirror post. The HOTPass® transponder is secured using 3M™ Dual Lock™ fasteners.
PAGE 2
roofline 3M™ Dual Lock™ strips orientation arrow transponder � in. minimum rear view mirror post HOTPass® Transponder - Rear View Preferred Mounting Location - Front View 2. If there is insufficient space in the preferred location, select an alternate mounting location beside the rear view mirror post: ©Kapsch TrafficCom IVHS. All rights reserved. Subject to alteration without notice. 4. Remove the protective backing from the two Dual Lock fasteners. � in. preferred, 2 in. maximum 5.