Owner's Manual

Handheld Reader (HHR) – Owners manual A316000-855
file: HHR Owners manual Rev. A ©2003 MKIV IVHS
IAG FPT
IAG FPT
Best
OK
Not OK
Description:
The handheld reader (HHR) by itself performs as an IAG tag functional verifier and CRC status
checker. Audible and visual indicators provide recognition of the tag status.
How to read a tag.
The tag must be an IAG tag or have an IAG compatible data format. Place the tag to be read
underneath the handheld reader, see Fig. 2. Press the push button switch for about 1 second
and release it. The LEDs and audible tone indicate the tag status as follows:
audible tone
push button
switch
red, yellow, green
LEDs
Table 1- LED and tone status indications
Red Yellow Green Tone Tag status
off off off 2 short beeps tag not read
off off
on steady for
5 seconds
4 short beeps tag is OK
flashing off off
on steady for
5 seconds
tag data is faulty, CRC is in error
off flashing off 8 long beeps Some data OK but CRC is in error
Fig. 2 - Position the HHR over the tag to be read
Note: it is best to have the arrows on the antennae surfaces of both the reader and the tag aligned in the same direction
and “opposed”.
Hold the HHR about 1-8 inches
away from the tag surface.
Press the push button switch for
about 1 second and release it.
If the tag is not read, move the
HHR closer to the tag and try
again.
Note: the HHR reads only IAG d
formatted tags.
ata
HHR Specifications (P/N 801283-247) Manual revisions
Note: specifications are subject to change without notice.
Rev Date Type Description
A1 24-Sept-03 none Initial release
A2 7-Oct-03 add HHR part number
A3 10-Oct-03 add FCC Advisement
A4 29-Oct-03 change FCC Advisements
• FCC ID: JQU801283
• Operating temperature range: 0°C to 45°C.
• Storage temperature range: -40°C to +85°C for up to 24 hours
• Humidity: 5% through 95% R.H. (non-condensing).
• Shock and vibration: designed for portable use only.
• Operating life (battery): 2+ years, under normal use
• Dimensions: width 80 mm, length 110 mm, depth 13 mm to 23 mm
• Weight: 107 grams
FCC Advisements
MARK IV
FCC ID: JQU 801283
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1. This device may not cause harmful interference, and,
2. this device must accept any interference received,
including interference that may cause undesired operation.
Warning: changes and/or modifications not expressly approved by
Mark IV Industries Ltd. could void the user’s authority to operate the
equipment.