WYZE SPRINKLER CONTROLLER Manual WSPRK1
Introduction Congratulations on purchasing a Wyze Sprinkler Controller. This Quick Reference Guide describes how to install, operate, and maintain your controller. Please read the instructions below.
Controller Stations Wyze Sprinkler is an 8-station controller. Each station is connected to a sprinkler valve. The specific valve turns on when it receives a signal from the controller, and then the sprinkler will start watering. When the watering task is finished, the controller will shut off the valve and turn on the next one in sequence.
Step 2 Installing anchors Tap the anchors into the holes on the wall. Step 3 Mounting Screw the mount on the wall. Step 4 Wiring Connect power adapter, valve wires and sensors to corresponding terminals.
Step 5 Installing controller Place the back of the controller at the lower end of the mount and push the controller up into the mount. Step 6 App setup Download the Wyze APP and select “Add a product”, then the app will guide you to complete the setup process. After finishing the system setup, you can create the irrigation tasks.
Manual Controls You can run the zone watering easily on the device. Press the left and right button to select a zone. Press the WATERING button (the upper one) to start a quick run immediately and press the STOP button (the lower one) to stop the watering. Troubleshooting One or more stations do not turn on: 1. Faulty valve. 2. Wire broken or not connected. One station is stuck on and will not shut off: 1. Faulty valve. 2. Particles of dirt or debris stuck in the valve. 3. Valve diaphragm faulty.
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the followi ng two conditions: (1) this device may not cause harmful interference, and (2) this de vice must accept any interference received, including interference that may c ause undesired operation. Changes or modifications not expressly approved by the party responsible for compl iance could void the user’s authority to operate the equipment.
ISED Statement -English: This device complies with Industry Canada license‐exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause in terference, and (2) This device must accept any interference, including interference t hat may cause undesired operation of the device.The digital apparatus complies with Canadian CAN ICES‐3 (B)/NMB‐3(B). ‐ French:Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.