Installation Instructions

3M double side tape

4 Volume Levels

volume high

volume medium

volume low

no sound but with flash

Just press the melody button of the receiver for more than 6

seconds and release it .

Clear Memory

Receiver：

98275USA

Transmitter：90047USA,90059USA,SN20002USA,SN20003USA

①

②

③

④

0-115dB



＜2 Mins

＜6 sec

Cleaning

Clean the outside of the device with a slightly damp cloth.

Do not use cleaning agents or solvents.

Never submerge device in water while cleaning.

NOTICE! Risk of product damage!

PAGE 1
Clear Memory ＜2 Mins 3M double side tape 38 ＜6 sec 38 Receiver：98275USA Transmitter：90047USA,90059USA,SN20002USA,SN20003USA 0-115dB 3M double side tape Just press the melody button of the receiver for more than 6 seconds and release it . 12 4 Volume Levels ① volume high ② volume medium ③ volume low ④ no sound but with flash 12 Cleaning NOTICE! Risk of product damage! Never submerge device in water while cleaning. Clean the outside of the device with a slightly damp cloth.
PAGE 2
Note Troubleshooting The doorbell only works at short distance: Avoid placing the doorbell or bell push on metallic surfaces. Move the doorbell to a new location. METAL 0-20% BRICK WOOD OPEN AIR 60-80% 80-90% 90-100% Doorbell will not ring when push button is pressed: Metallic surface may reduce transmitter power. Range Guide Ensure the doorbell is switch on. Follow the “clear memory” guide to reset to doorbell, then follow the “pairing” steps to setup the doorbell.