User's Manual

ManualsBrandsKanematsu USA ManualsElectronicsUHF Transceiver

BS HH1 6

Users Manual

INTRODUCTION

This Manual describes the operation for the Kanematsu Handheld radio

This Handheld is full-featured FM transceiver designed for flexible mobile business

communications in the VHF or UHF Land mobile bands.

This Land mobile radio can be programmed with 16 channels.

Important channel frequency data is stored in EEPROM and flash memory on the CPU,

and easily programmable by dealers using personal computer and PC EDITER software.

FCC Requirements

Your radio must be properly licensed Federal Communications Commission prior

to use. Your Wireless dealer can assist you in meeting these requirements. Your

dealer will program each radio with your authorized frequencies, signaling codes,

etc., and will be there to meet your communications needs as your system

expands.

This device complies with part 15 of the FCC Rules. Operation is subject to the

Condition that this devices does not cause harmful interference.

NOTE: The manufacturer is not responsible for any radio or TV

interference caused by unauthorized modifications to this

equipment. Such modifications could void the user's authority to operate the

equipment.

Summary of content (6 pages)

PAGE 1
BS HH1 6 Users Manual INTRODUCTION This Manual describes the operation for the Kanematsu Handheld radio This Handheld is full-featured FM transceiver designed for flexible mobile business communications in the VHF or UHF Land mobile bands. This Land mobile radio can be programmed with 16 channels. Important channel frequency data is stored in EEPROM and flash memory on the CPU, and easily programmable by dealers using personal computer and PC EDITER software.
PAGE 2
SAFETY WARNING INFORMATION READ THIS IMPORTANT INFORMATION ON SAFE AND EFFICIENT OPERATION BEFORE USING YOUR LAND MOBILE RADIO Only qualified technicians are allowed to repair this product. Do not operate the radio without a proper antenna attached. As this may damage the radio and may also cause to exceed FCC RF exposure limits. Typical electronic systems that may malfunction due to the lack of protection from radio frequency energy present when transmitting.
PAGE 3
Control and Connectors FRONT PANEL 1 VOL/PWR Knob (3) Turn this control clockwise to turn the radio on and increase the volume. Turn it counterclockwise into the click-stop to the radio off.
PAGE 4
3 Channel Selectable Knob (2) Selectable channel Knob. 4 UDC Terminal (7) Connect the microphone or speaker. An external loudspeaker may be connected to this 2-contact. Caution: Do not connect either wire of this line to ground, and be certain that the speaker has adequate capability to handle the audio output (4W) from the radio. 5 Moniter Buttons (6) All channel activity can be monitored by pressing the button. 6 SCAN Button (5) Switches the Scan Mode on and off.
PAGE 5
Select a Channel Use the rotary switch (channel knob) to select the operating channel. Transmitting Press the Monitor button to listen for channel activity When receiving a call, transmit only after the incoming call ends. The radio cannot receive a call and transmit simultaneously. Press PTT switch. If the channel is clear, the BUSY/TX indicator will grow red. The radio is now transmitting. While holding in the PTT switch, speak across the face of the microphone in a clear and normal voice.
PAGE 6
Press the monitor button hears background noise (unmute the audio); the BUSY/TX indicator will grow green. SCAN The Scanning feature is used to monitor multiple channels programmed into the transceiver. While scanning, transceiver will check each channel for the presence of a signal, and will stop on a channel if a signal is present. Press the SCAN button to active scanning.