BS HH16 Users Manual
INTRODUCTION This Manual describes the operation for the Kanematsu Handheld radio This Handheld is full-featured FM transceiver designed for flexible mobile business communications in the VHF or UHF Land mobile bands. This Land mobile radio can be programmed with 16 channels. Important channel frequency data is stored in EEPROM and flash memory on the CPU, and easily programmable by dealers using personal computer and PC EDITER software.
- clip shown in the picture (9 Belt Clip). Using approved belt clip that maintain a “separation distance” between the User and the radio complies with the 1.5 cm separation distance. Use of non-approved belt clip may result in exposure levels, which exceed the FCC occupational/controlled environment RF exposure limits. If User are not using a body-worn belt clip and are not using the radio in the intended-use position in front of the face, ensure the antenna and the radio are kept at least 1.
Control and Connectors FRONT PANEL 1 VOL/PWR Knob (3) Turn this control clockwise to turn the radio on and increase the volume. Turn it counterclockwise into the click-stop to the radio off. 2 BUSY/TX Indicator Indicate transceiver Transmit/Receive Status Steady Red: Transmitting(High) in progress Steady Orange: Transmitting(Low) in progress Steady Green: Busy Channel 3 Channel Selectable Knob (2) Selectable channel Knob. 4 UDC Terminal (7) Connect the microphone or speaker.
Monitor Buttons (6) All channel activity can be monitored by pressing the button. 6 SCAN Button (5) Switches the Scan Mode on and off. 7 Antenna Connector ( 1) The 50-ohm to the antenna must be connected here, using a SMA plug. 8 9 136-160MHz 150-174MHz P/N: PA020AA10 P/N: PA021AA10 7.5V DC Input The supplied Battery must be connected to this 2-contact.
BASIC OPERATION Important! – Before turning on the radio the first time, confirm that the power connections have been made correctly and that a proper antenna is connected to the antenna jack. Overview - Your authorized Dealer can program your radio for Conventional format. RECEIVE Switching Power ON Turn power on by the VOL/PWR knob. The radio will beep. Setting the volume Turn the VOL/PWR knob clockwise to increase the volume, and counterclockwise to decrease it.
Time-Out Timer If the selected channel has been programmed for Time-Out timer, you must limit the length of each transmission, Wile transmitting, a beep will sound 10 seconds before time-out. Another beep will sound just before the deadline; The TX indicator will disappear the transmission will cease soon thereafter.