User's Manual

ManualsBrandsKan Tsang Technology ManualsClock RadiosBluetooth Digital Clock Radio

BRANDNAME

KT-3089BTUBTUBTU

DIGITAL DUALALARM FM CLOCK

RADIO WITH BLUETOOTH AND DUAL USB

CHARGING PORT

INSTRUCTION MANUAL

Thank you for buying Brandname’s product. Read this manual carefully to

get the best performance from this unit.

IMPORTANT

 Read these instructions.

 Heed all warnings.

 Follow all instructions.

 Do not block any ventilation openings, Install in accordance with the

manufacturer’s instructions.

 Do not install near any heat sources such as radiators, heat registers,

Summary of content (8 pages)

PAGE 1
BRANDNAME KT-3089BTUBTUBTU DIGITAL DUAL ALARM FM CLOCK RADIO WITH BLUETOOTH AND DUAL USB CHARGING PORT INSTRUCTION MANUAL Thank you for buying Brandname’s product. get the best performance from this unit. Read this manual carefully to IMPORTANT  Read these instructions.  Heed all warnings.  Follow all instructions.  Do not block any ventilation openings, Install in accordance with the manufacturer’s instructions.
PAGE 2
stoves, or other apparatus (including amplifiers) that produce heat.  Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the clock radio.  Only use attachments/accessories specified by the manufacturer.  Unplug this clock radio during lightning storms or when unused for long periods of time.  Refer all servicing to qualified service personnel.
PAGE 3
recycling device. (Batteries pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. LOCATION OF CONTROL 1. 2. 3. TIME SET / MEMORY /PLAY/PAUSE DIMMER/ SLEEP/ SCAN VOLUME + / AL2 4. 5. VOLUME - / AL1 SNOOZE / NIGHT LIGHT 6. 7. 8. / FUNCTION 9. AL1 INDICATOR 10. PM INDICATOR 11. BLUE TOOTH INDICATOR 12. AL2 INDICATOR 13. SLEEP INDICATOR 14. DIGITAL DISPLAY TUNING DOWN / HOUR / SKIP BACKWARD 15. DC INPUT TUNING UP / MINUTE / SKIP FORWARD 16.
PAGE 4
voltage printed on the back or underside of the clock radio.  Risk of electric shock! When you unplug the AC adaptor, always pull the plug from the socket. Never pull the cord. BOTTOM OF SET Battery compartment for 1.5 volt (LR6, UM-3, AA) battery 2pcs. (not included) for temporary time storage. SET TIME 1. Press and hold TIME SET for two seconds. 2. Preset 24 shows 24 hour mode . 3. Press TUNING ＾﹀ to select 24 or 12 hour mode . 4. Press TIME SET to confirm 24 or 12 hour mode .
PAGE 5
STORE FM RADIO STATIONS MANUALLY. 1. Tune to an FM radio station. 2. Press the MEMORY TIME SET to activate the storing mode. 3. Press the TUNING ＾﹀ to select the preset number. 4. Press the MEMORY TIME SET again to store the radio station .  [P 01 ~ P 20] is preset station numbers.  If this position is occupied, the previous stored frequency will be displayed ;  To remove a pre-stored FM radio station, store another station in its place. LISTEN TO A PRESET FM RADIO STATION 1.
PAGE 6
SET ALARM TIMER Make sure that you have set the clock correctly. You can set two separate alarm timers. For the alarm sound, you can select the FM radio or the buzzer. 1. Press / SCAN to Clock mode. 2. Press and hold AL1/AL2 for two seconds.  [0:00] Hour digit is blink. 3. Press TUNING ＾ to set the alarm hour and TUNING ﹀ to set the alarm minute. 4. Press AL1/AL2 to confirm setting . 5. Press AL1/AL2 again to select a sound source: FM or BUZZER.
PAGE 7
OFF ADJUST VOLUME While listening, press + VOLUME – to adjust volume. ADJUST DISPLAY BRIGHTNESS Press and hold DIMMER for 2 seconds repeatedly to select high or low brightness levels. Plug the unit into the USB port on your computer or into a USB power adaptor (not included) using the included USB cable. BATTERY BACK-UP (For Temporary Time Storage Only) Install 2 x LR06, AA or EU-3 battery (not included) according to polarity shown inside the battery compartment.
PAGE 8
FCC Cautions: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.