User Manual

ManualsBrandsKamstrup ManualsElectronicsUSB Meter Reader

55121179_B1_GB_10.2012

21. Select “Install the software automatically”, and then click

“Next”.

22. Enter a name for the USB Reader. If you have several USB

Readers, name them all.

23. Create meters, groups and job lists as described in the online

user manual.

The online manual is available under the Help menu in the program

and in Windows under Start –> All Programs –> Kamstrup and from

www.kamstrup.com.

Charging of Power Pack

Before using Power Pack (the battery part), it must be charged. Charge

it with the enclosed charging cable that should be mounted in Power

Pack and the PC, after which the charging will start automatically.

Power Pack is fully charged when the light emitting diode in the mid-

dle of the round button on the front of Power Pack emits green light. It

takes approx. 5-8 hours.

Summary of content (4 pages)

PAGE 1
3 21. Select “Install the software automatically”, and then click “Next”. 22. Enter a name for the USB Reader. If you have several USB Readers, name them all. 23. Create meters, groups and job lists as described in the online user manual. The online manual is available under the Help menu in the program and in Windows under Start –> All Programs –> Kamstrup and from www.kamstrup.com. Charging of Power Pack Before using Power Pack (the battery part), it must be charged.
PAGE 2
55121179_B1_GB_10.2012 USB Kamstrup Meter Reader Kamstrup A/S Industrivej 28, Stilling DK-8660 Skanderborg Tel.: +45 89 93 10 00 Fax: +45 89 93 10 01 info@kamstrup.com www.kamstrup.
PAGE 3
1 FCC Cautions Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. RF Exposure compliance statement: This device may be used in portable exposure conditions with no restrictions, since the sourcebased time-averaged output power is ≤ 60/f(GHz) mW. This device complies with Part 15 of the FCC rules.
PAGE 4
2 Installation of Software 1. Start the Internet browser and connect to the website www. kamstrup.com. 2. Under “Online services”, select “USB Meter Reader Software”. 3. Fill in the form and click on “Send”. 4. Click on “Confirm” to continue or “Back” to correct your data. 5. You will receive an e-mail with a link for software download. 6. Click on the link and select “Download”. 7. Select “Run” twice. The program is now saved to your PC. 8. Select “Next ”. 9.