User Manual

ALWAYS use new gaskets
(Kamstrup recommends
EPDM).
The sealing surface of
the threaded connection
must be clean and level.
The adjacent piping must be parallel
and match the meter in- and outlet.
Torque
If a pipe installation is skewed to the effect that the prescribed
tightening torques would be exceeded, a meter setter or yoke
should be installed.
1” Max. 30 Nm
1”: Max. 30 Nm
flowIQ® 2250
Installation guide
Kamstrup A/S • DRAFT_55122048_A1_US_02.2017
Optional customer label, (not an option for Encoded Output version)
Optical eye for reading and configuration
Digital display showing consumption
Type number
(includes information on meter
size, overall length etc.)
Bar code with serial number
FCC identification
Protection Class IP68 (Waterproof/submersible)
FCC Cautions
Caution: Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
RF Exposure compliance statement: This device may be used with
no restrictions, since the source-based time-averaged output power
is ≤ 60/f(GHz) mW.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1 This device may not cause harmful interfenrence, and
2 This device must accept any interference received, including
interference that may cause undesired operation.
Temperature range
Nominal meter size
Max. flow for continous operation
Do not overtighten; max 30 Nm or 1/4 turn beyond handtight.
Toggle between volume, flow and
SW version via fingertouch