User Manual

www.kamstrup.com
Installation guide for
flowIQ 2100
Optional customer label, e.g. water company logo (15x38 mm)
Optical eye for reading and configuration
Graphic flow indicator
Type number
(includes information on
meter size, overall length etc.)
Serial no. and prod. year
Configuration
(with information on display
resolution and encryption level etc.)
Accuracy class 2 according to OIML R 49
Environment class: Electrical E2 and Mechanical M1 according to MID
Environment class B and C according to OIML R 49
(indoors/outdoors)
Bar code with serial number
Expiry year of battery
Temperature class according to OIML R 49
Nominal meter size
Software version
FCC identification
55121224_A1_GB_10.2012
ALWAYS use new gaskets
(PE or EPDM).
The coupling’s
sealing surface must
be clean and even.
The piping must be parallel and match the meter.
With your smart phone you can enter this QR code and
watch our installation film online. Or you can watch the film
on http://www.kamstrup.dk/hardlink/mc21/index.html.
Torque
If a pipe installation is skew to the effect that the prescribed
tightening torques would be exceeded, a telescopic
coupling ought to be installed.
1”
Max. 30 Nm
1”: Max. 30 Nm
FCC Cautions
Caution: Changes or modifications not expressly approved
by the party responsible for compliance could void the
user’s authority to operate the equipment.
RF Exposure compliance statement: This device may be
used with no restrictions, since the source-based time-
averaged output power is ≤ 60/f(GHz) mW.