Installation & Assembly

Sealant Tape

1/8"

Plus:

• 1-1/4" copper tube or 1/2" nipple

• Emery paper

Clear 100%

Silicone Sealant

Stainless

Plumbers Putty

Use emery paper to remove burrs.

Slip-Fit Spout: Install the tube

1-9/16" (40 mm) from the wall.

Install the escutcheon on the

spout.

Important Information

Observe all local plumbing and

building codes.

Record your model number below

for future reference:

1/8"

Loosen the setscrew to remove the

slip-fit assembly.

Install the nipple 1-3/4" (44 mm) from

the wall.

Threaded Spout: Apply sealant

tape to a 1/2" nipple.

1/8"

Loosen the setscrew. Slide the spout

and escutcheon against the wall.

Tighten the setscrew.

Apply plumbers putty or sealant to

the escutcheon, leaving a gap at the

bottom.

Wipe away excess sealant.Use a clean strap wrench to install

the spout.

Apply plumbers putty or sealant to

the escutcheon, leaving a gap at the

bottom.

1284109-2-A

PAGE 1
Stainless Plumbers Putty 1/8" Record your model number below Important Information for future reference: Observe all local plumbing and building codes. 1 Install the escutcheon on the spout. Sealant Tape Clear 100% Silicone Sealant 2 Slip-Fit Spout: Install the tube Plus: • 1-1/4" copper tube or 1/2" nipple • Emery paper Use emery paper to remove burrs. 1-9/16" (40 mm) from the wall. X Apply plumbers putty or sealant to Loosen the setscrew.
PAGE 2
Questions? Problems? For additional assistance, please contact KALLISTA's Customer Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.