User's Manual
� W indows Driver Installation
Please follow the steps below to install your new wireless network
card:
1. Insert the device driver CD into the CDROM drive on your
computer, double-click the Setup.exe icon and run the
Setup.exe program.
2. SelectI accept the terms of the license agreement and then
click Next.
3. Select the setup type that best suits your needs, Install driver
and Ralink WLAN Utilityis recommended.
4. Click Next, the Select Configuration Tool window will
appear,you can manage this wireless adapter by either
theRalink Configuration Toolor theMicrosoft Zero
Configuration Tool.
5. Click Next,the ready to installwindow will appear.
6. Click Install, and wait while the installation is in process.
7. Finally, click Finish to complete the driver installation.
� Connect to a Wireless Access Point
1. After installation has finished, it will automatically try to connect
to any unencrypted wireless access point. If you want to
connect to a specific wireless access point, or the access point
you want to connect to uses encryption, you have to configure
the wireless network card and input the correct password to
connect to the wireless access point. To do this, double-click
the icon.
2. The following window will appear:
3. Click the icon to scan available wireless access
points.
Scan results will display in the Network zone. If you can＇t find
the access point you want to connect to, click the refresh
button, until yourwireless access point is displayed.
4. Double-click the wireless access point’s SSID you want to use.If
the access point is encrypted, you should follow the prompts to
select the appropriate encryption type and enter your password.
5. After you have connected to the wireless access point
successfully, you can get detailed information on the connected
access point such as status, IP address, speed, etc. Click the
icon
then the icon here you will see the signal quality and
signal strength information.
This equipment has been
tested and found to comply
with the limits for a Class B
digital device,
pursuant to part 15 of the FCC
Rules.
These limits are designed to
provide reasonable protection
against harmful interferece in a
residential installation.
Wireless N300 Dual Band USB Adapter