Document No.
Document No. Revision: BLE Module Installation Guide 3 Prepared by: Charles Grimm Date: 10/22/2015 REVISION HISTORY Rev. 1 Date 10/22/2015 Description Release of document Made by Checked Approved CG TABLE OF CONTENTS 1. INSTALL DOUBLE DECKER END CAP .................................................................................................................................... 3 2. LABEL UPGRADES AND ADDITIONS ..............................................................................
Document No. BLE Module Installation Guide Prepared by: Charles Grimm Revision: 3 Date: 10/22/2015 1. Install Double Decker End Cap Install the communication boards as shown. RF board is in the upper position if present. BLE board is in the lower position. Ensure the wires run through the notch in the cap so they do not become pinched when the cap is installed on the chassis. Install the end cap onto the chassis by pressing it over the screw post as shown.
Document No. BLE Module Installation Guide Prepared by: Charles Grimm Connect the BLE module wire harness to the MT4 PCB as shown. Ensure all wires are connected and routed properly and will not be pinched when the cover is reinstalled.
Document No. Revision: BLE Module Installation Guide 3 Prepared by: Charles Grimm Date: 10/22/2015 2. Label Upgrades and Additions Ensure the “DEAD BOLT CAM POSITION” label is replaced with the latest MT4 version. Part Number: A37780 The FCC Enclosure label for the BLE board must be added to the lock and will be placed as shown for field upgrades. Note: Part displayed is the inside cover Reinstall the escutcheon and tighten the screws with a tamper resistant T20 bit.